thanks Struth.
this brush I mention does seem on the 'stiff' side for carbon fibre ... as I say I'll try and get a piccy or two up at some point. Although you have to get the light 'right' to see the marks, once you do, they certainly aint subtle...

the dustbug I mention is much less likely to cause trouble I would hope, if balanced correctly... but then again ...

Quote Originally Posted by struth View Post
I use stiff nail brush on some bad ones and it doesnt scratch if used right way so you shouldn't cause any marks with a fibre one if you do it right. Dusting a clean one i put it on turntable and spin it .lay brush on and work in to label to spindle then lift..usually not much there if its been cleaned and anti staticed at last use or clean.. The antistatic pistols are good to reinforce what your cleaning solution should do static wise