Quote Originally Posted by cuddles View Post
Here's a question for Okki Nokki users - how do you remove the pads from the suction arm? I could do with a fresh set but rather than going in like a bull at a gate I would prefer a measured approach
Just rip'em off, they are made from some form of fabric and can take quite a beating. I actually usually reuse them once, just change their postion (or rotate each one 180 degrees)
You just use a few mm's of the edge, the rest is new!
(And the glue usually works just fine once more)

If you are replacing them, clean the suction tube thoroughly with a gentle glue remover and then a degreaser. Otherwise the new pads wont stick properly...
Atb Mike