+ Reply to Thread
Page 5 of 6 FirstFirst ... 3456 LastLast
Results 41 to 50 of 52

Thread: Albarry's

  1. #41
    Join Date: Nov 2009

    Location: Devon

    Posts: 1,903
    I'm stu.

    Default

    Quote Originally Posted by trio leo View Post
    I agree with you Simon, I went to Whittlebury and heard the Albarry dem, it was OK with some kinds of music but not so with others, the room wasn't good and I thought maybe the speakers were a bit too big for that room.

    I hope you get the chance to hear them in a better environment, or maybe hear them at home.
    The trick with Albarry's is to leave them switched ON, permanently, my M408's have been on for 25 years and they are still exciting.

    Enjoy your music

    regards Al

    Why?
    301/Puresound 2A3/quite large Grf cab horny ones.Eminence/Coral/Le cleach

  2. #42
    Join Date: Feb 2011

    Location: Wales

    Posts: 8,043
    I'm NotAnAudiophile.

    Default

    Quote Originally Posted by trio leo View Post
    The trick with Albarry's is to leave them switched ON, permanently
    That's the advice Neil (Burnett) gave me for the PP1 - he was right too


    Some people have no idea what they're doing and a lot of them are really good at it.
    George Carlin

    Boycott the US

  3. #43
    Join Date: Feb 2011

    Location: Ramsbottom

    Posts: 637
    I'm Alan.

    Default Albarry's

    It was explained to me that the capacitors get up to 62.3% very quickly, then it takes quite a while to fully charge up.
    I don't know an Ohm from a watt, but it is not to do with the actual temperature when they "warm up" it's to do with the capacitors apparently.

    I think the power amps from "cold" sound uninviting, but after 20-30 minutes you can hear them become more lucid.

    It states in the hand book that comes with the amps that one should allow 24 hrs for optimum performance and according to Neil they are designed to be left on, the pre-amp and power amps combined use 8 watts when in "standby" mode.

    Given that they use so little energy and they are so reliable, leave them on IMO.

    Enjoy your music

    regards Al
    My system,

    Cartridges Lyra Delos, Audio Technica AT33EVmc, AT 24 mm
    Turntable Thorens TD 124 Mk2, in a Jim Campbel plinth,Audio Technica 1503 Mk3 arm
    CD player Technics SL-PG490
    Cassette deck Yamaha KX 530
    Moving Coil Amp Albarry MCA 11
    Pre-amplifier Albarry AP 11 (battery powered)
    Power amps Albarry M1108 Mono-blocs
    Speakers Allison 3 Corner units, Allison 6 stand mounted cubes
    Interconnects AVT Matrix 6 and OFC short ones
    Mains distribution Music Works Recoil 6 gang and mains leads
    Tables MusicWorks ReVo acrylic stand, Quadraspire Acrylic shelves (cryo'd legs) acrylic Response Mini under mains block.
    Speaker cable Chord Rumour (Cryo'd)
    RCM Okki Nokki
    https://www.facebook.com/groups/1586...homepage_panel

  4. #44
    Join Date: Apr 2008

    Location: Warrington

    Posts: 3,438
    I'm Neil.

    Default

    Quote Originally Posted by Tim View Post
    That's the advice Neil (Burnett) gave me for the PP1 - he was right too
    ..same with LFD and Exposure they are a bit bright when you first switch them on. Sounds way better when left on all the time same with my NVA headphone amp and I suspect the same with Naim amps...
    Mana Acoustics Racks / Bright Star IsoNodes Decoupling >> Allo DigiOne Player >> Pedja Rogic's Audial Model S DAC + Pioneer PL-71 turntable / Vista Audio phono-1 mk II / Denon PCL-5 headshell / Reson Reca >> LFD DLS >> LFD PA2M (SE) >> Royd RR3s.

  5. #45
    Join Date: Apr 2008

    Location: Cheshire, UK

    Posts: 2,832
    I'm Clive.

    Default

    Quote Originally Posted by trio leo View Post
    The trick with Albarry's is to leave them switched ON, permanently, my M408's have been on for 25 years and they are still exciting.
    Has your amp been re-capped in that time? Electrolytic capacitors in use continuously for 25 years have to be shagged by now! 219,000 hours is a loooong time, the most important factor in determining their their lifetime is temperature but those caps are elderly whatever the temp.
    TT 1 Trans-Fi Salvation with magnetic bearing + Trans-Fi Terminator T3Pro + London Reference
    TT 2 Garrard 301 with NWA main bearing + Audiomods Series Six 10.5" + Ortofon 2M Mono SE
    Digital Lindemann Bridge + Gustard R26 with LB external clock
    Pre and Power Amp EWA M40P + M40A
    Bass Amp & DSP Behringer iNuke NU3000DSP x 2
    Speakers 1 Bastanis Sagarmatha Duo with twin baffleless 15" bass drivers per side
    Speakers 2 MarkaudioSota Viotti Tower

  6. #46
    Join Date: Feb 2010

    Location: SE London

    Posts: 501
    I'm Andrew.

    Default

    I have a dumb question, but its bugged me for years. With these power amps that need to be left on and warmed up for a day, what happens if you switch them off for a few minutes? Do you have to start all over again? This is a critical question when comparing pre-amps. Can I switch off for a minute to change pre-amps without having to warm up again for 24 hours? Sorry, its probably very obvious.

  7. #47
    Join Date: Apr 2008

    Location: Cheshire, UK

    Posts: 2,832
    I'm Clive.

    Default

    If the capacitors really take 24 hours to reach full charge (very, very weird) then having speakers plugged into the amp outputs will probably discharge them. If the amps are stable without a load across their outputs then removing the speaker connections may prevent the capacitors discharging.
    TT 1 Trans-Fi Salvation with magnetic bearing + Trans-Fi Terminator T3Pro + London Reference
    TT 2 Garrard 301 with NWA main bearing + Audiomods Series Six 10.5" + Ortofon 2M Mono SE
    Digital Lindemann Bridge + Gustard R26 with LB external clock
    Pre and Power Amp EWA M40P + M40A
    Bass Amp & DSP Behringer iNuke NU3000DSP x 2
    Speakers 1 Bastanis Sagarmatha Duo with twin baffleless 15" bass drivers per side
    Speakers 2 MarkaudioSota Viotti Tower

  8. #48
    Join Date: Apr 2009

    Location: Near Saffron Walden, Essex

    Posts: 7,367
    I'm Dave.

    Default

    You needn't lose any sleep over such matters. All amps sound better once they are warmed up but this usually occurs after an hour or so and it isn't a night and day difference - just a very slight change.

  9. #49
    Join Date: May 2008

    Location: A Strangely Isolated Place in Suffolk with Far Away Trains Passing By...

    Posts: 14,540
    I'm David.

    Default

    I'd also respectfully repeat that the 608's have the benefit of more modern and better intrinsically matched components these days. This in itself should enable the amps to fully stabilise much quicker now.
    I can't go on and I can't go back, I don't feel so matter of fact,
    I tried and tried to make good sense, What's the good to try it all again?

  10. #50
    Join Date: Feb 2011

    Location: Ramsbottom

    Posts: 637
    I'm Alan.

    Default

    To be honest Clive, Neil (Burnett) "serviced" them about 6 years ago, I don't know if they were recapped or not, they sounded good before and they sound good now, maybe they were re-capped, but 20 years or so on original capacitors is pretty good eh.

    I'm not saying they NEED 24hrs to fully charge up, as HiFi Dave said they sound fine after an hour or so as probably a lot of amps do, I'm not being drawn into an argument about capacitors, I don't know the first thing about electronics, as I stated before it is how Neil explained it to me.

    I have faith in Neil, he designs amps to last a long time and I enjoy the musical involvement Albarry's bring to my system, especially the little moving coil amplifier, it has enhanced my enjoyment of my Vinyl collection tremendously.

    I'll be glad when I can afford a new pre / power combo

    enjoy your music

    regards Al
    Last edited by trio leo; 03-08-2012 at 12:14.
    My system,

    Cartridges Lyra Delos, Audio Technica AT33EVmc, AT 24 mm
    Turntable Thorens TD 124 Mk2, in a Jim Campbel plinth,Audio Technica 1503 Mk3 arm
    CD player Technics SL-PG490
    Cassette deck Yamaha KX 530
    Moving Coil Amp Albarry MCA 11
    Pre-amplifier Albarry AP 11 (battery powered)
    Power amps Albarry M1108 Mono-blocs
    Speakers Allison 3 Corner units, Allison 6 stand mounted cubes
    Interconnects AVT Matrix 6 and OFC short ones
    Mains distribution Music Works Recoil 6 gang and mains leads
    Tables MusicWorks ReVo acrylic stand, Quadraspire Acrylic shelves (cryo'd legs) acrylic Response Mini under mains block.
    Speaker cable Chord Rumour (Cryo'd)
    RCM Okki Nokki
    https://www.facebook.com/groups/1586...homepage_panel

+ Reply to Thread
Page 5 of 6 FirstFirst ... 3456 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •