clarkey555
11-07-2016, 16:28
Selling my much loved and cherished croft series 7 phono integrated amplifier with original box. In excellent as new condition.
TECHNOLOGY
Fitted with a pair of ECC83 drivers operating in Class A mode and driving two MOSFET output devices per channel, the GC-i is rated at approximately 40-50Wper channel rms, with 8 ohm loads. Part of the company's new Transvalve line, it's a design that is ".basically similar to Croft's long-serving, familiar output-transformerless circuits, but translated to new circuitry," according to Amar Biswas of Eminent Audio. (Glenn Croft himself redefines "reclusive".)
It was explained that this Croft integrated was designed using all-valve references, with MOSFETs substituted into the valve equivalent, so spiritually, at least--the GC-i is a valve amp. It reminded me of the point made by Tim de Paravicini's first Yoshinos; both single-ended, but one solid-state and one valve.
Inside the 75 x 405 x 315mm (hwd) case is total adherence to Croft values. In other words, no PCBs-everything being hard-wired. There are even strips of copper for the earthing - vertical constructs to hold the active devices. And when you pick it up, it seems a bit unbalanced, that's down to the massive 300VA toroidal power supply fitted in the left-hand side. Large capacitors, rock-solid construction, not one unnecessary "bit" - truly tidy wiring.
£700 ONO
Ta.
http://uploads.tapatalk-cdn.com/20160712/a9c25f26fed3a6565676e42b0f9982de.jpg
http://uploads.tapatalk-cdn.com/20160712/04d4580c9ef17dd143b7e49cf8b52e37.jpg
http://uploads.tapatalk-cdn.com/20160712/37dd72f09533621b5a08c2f9521a78cc.jpg
http://uploads.tapatalk-cdn.com/20160712/6a651ad760b0960f4d38aa592fb881aa.jpg
http://uploads.tapatalk-cdn.com/20160712/08c10f244e5139b904dcc38213cbca5c.jpg
New Releases! A selection of Integrateds and upgraded phono stages.
New Croft Integrateds
After what seems an eternity Glenn is finally ready to announce new products. The following have been in development for around eighteen months and the prototypes have been tested in various levels of hifi sytem. The casework is the same as before but with some new retro silver knobs. For us it's what's on the inside that counts and here is where Glenn always delivers.
Below is the new Croft Phono Integrated priced at £1000.
The Phono Integrated is basically a Series 7 amplifier but with a Micro 25 phono stage. I have been listening to it for the last week am pleased to say that there is almost no difference between it and the two box setup. So all in all great value and a convenient solution for those who prefer an integrated over a multi-box setup.
The new Croft RIAA phono stage
The new Croft Phono Integrated (£1000)
Sent from my iPhone using Tapatalk
TECHNOLOGY
Fitted with a pair of ECC83 drivers operating in Class A mode and driving two MOSFET output devices per channel, the GC-i is rated at approximately 40-50Wper channel rms, with 8 ohm loads. Part of the company's new Transvalve line, it's a design that is ".basically similar to Croft's long-serving, familiar output-transformerless circuits, but translated to new circuitry," according to Amar Biswas of Eminent Audio. (Glenn Croft himself redefines "reclusive".)
It was explained that this Croft integrated was designed using all-valve references, with MOSFETs substituted into the valve equivalent, so spiritually, at least--the GC-i is a valve amp. It reminded me of the point made by Tim de Paravicini's first Yoshinos; both single-ended, but one solid-state and one valve.
Inside the 75 x 405 x 315mm (hwd) case is total adherence to Croft values. In other words, no PCBs-everything being hard-wired. There are even strips of copper for the earthing - vertical constructs to hold the active devices. And when you pick it up, it seems a bit unbalanced, that's down to the massive 300VA toroidal power supply fitted in the left-hand side. Large capacitors, rock-solid construction, not one unnecessary "bit" - truly tidy wiring.
£700 ONO
Ta.
http://uploads.tapatalk-cdn.com/20160712/a9c25f26fed3a6565676e42b0f9982de.jpg
http://uploads.tapatalk-cdn.com/20160712/04d4580c9ef17dd143b7e49cf8b52e37.jpg
http://uploads.tapatalk-cdn.com/20160712/37dd72f09533621b5a08c2f9521a78cc.jpg
http://uploads.tapatalk-cdn.com/20160712/6a651ad760b0960f4d38aa592fb881aa.jpg
http://uploads.tapatalk-cdn.com/20160712/08c10f244e5139b904dcc38213cbca5c.jpg
New Releases! A selection of Integrateds and upgraded phono stages.
New Croft Integrateds
After what seems an eternity Glenn is finally ready to announce new products. The following have been in development for around eighteen months and the prototypes have been tested in various levels of hifi sytem. The casework is the same as before but with some new retro silver knobs. For us it's what's on the inside that counts and here is where Glenn always delivers.
Below is the new Croft Phono Integrated priced at £1000.
The Phono Integrated is basically a Series 7 amplifier but with a Micro 25 phono stage. I have been listening to it for the last week am pleased to say that there is almost no difference between it and the two box setup. So all in all great value and a convenient solution for those who prefer an integrated over a multi-box setup.
The new Croft RIAA phono stage
The new Croft Phono Integrated (£1000)
Sent from my iPhone using Tapatalk