-
Denon DL-301 mk2 match with Technics stock tonearm + What headshell to use?
I was considering Denon DL-301 MK2 after reading a lot of good reviews. My question is, what about the headshell. I would like to update the stock headshell, but technics tonearm has 12g effective tonearm mass. And all the good headshells I see are 12g, so a little math:
(12-7.5+12) = 16.5g - effective tonearm mass with the new headshell.
where:
-7.5g stock technics headshell
12g - new headshell
And this will move the resonanse to a point, where it's not good, right?
Do you guys have any suggestion for a good headshell, that will sound better than the stock one?
-
http://www.resfreq.com/resonancecalculator.html
I used this calculator, and for total mass 22.5 + 10Hz desired fr. equals to 11.258 cu.
The DL-301 has Compliance: 13x 10-6cm/dyne
But I'm not sure in what units the cu is in the calculator, I'm still new to this stuff, any help will be appreciated.
Regards
-
Denon quote the compliance at 100Hz, whereas one really needs the dynamic compliance at ~10Hz. Depending on the exact cartridge the compliance at 10Hz is 1.5 - 2.0x the compliance at 100Hz.
The Denon 301/II has a quoted compliance at 100Hz of 13cu, so we will calculate the resonance frequency for 19.5 - 26cu. With a total mass of 22.5g, the calculated LF resonance frequencies are 6.5 - 7.5Hz. These are IMO too low, but depending on where and how your turntable is seated, you may get away with it and not experience any problems.
Barry
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules