Wanting something as simple as possible, what's best to go for, Volumio or Rune Audio?
Senior Member
Location: Near Oxford
Posts: 1,228
I'm Bill.
Wanting something as simple as possible, what's best to go for, Volumio or Rune Audio?
Grand Veteran
Location: Happy Cheshire
Posts: 737
I'm Duncan.
Prior to my last post regarding power supplies for the Pi.
I have just put this together and sound quality has improved over the stock smps.
There seems a more natural relaxed quality to the sound so probably worth doing, for a cost of around £30.
LM350 regulators were used instead of the LM317's for their higher current rating.
Last edited by tubehunter; 30-04-2015 at 23:39.
Senior Member
Location: Bristol, UK
Posts: 278
I'm Stephen.
Did you have to wait very long Marco from ordering your Paul Hynes supply to delivery tomorrow?
Thanks
Steve
Site Owner/Administrator
Location: Wrexham, North Wales, UK
Posts: 110,479
I'm AudioAl'sArbiterForPISHANTO.
Hi Stephen,
Not at all. It actually arrived this morning, but I was busy today and have only just had a chance to hook it up.
Initial impressions are very positive indeed, but I shall refrain from commenting further until the PSU has warmed up/run-in properly and I've got a proper handle on what it's doing, but I think I can safely say that this baby has raised the bar quite significantly
More later!
Marco.
Main System
Turntable: Heavily-modified Technics SL-1210MK5G [Mike New bearing/ETP platter/Paul Hynes SR7 PSU & regulator mods]. Funk Firm APM Achromat with Nagaoka GL-601 Crystal Record Weight. Isonoe feet & boots. Ortofon RS-212D tonearm with Denon DL-103GL, in a Denon PCL-300 headshell, fitted with Funk Firm Houdini and Kondo SL-115 pure-silver cartridge leads.
Paul Hynes MC head amp/SR5 PSU. Also modded Lentek head amp and Denon AU-310 SUT.
Other Cartridges: Nippon Columbia (NOS 1987) Denon DL-103. USA-made Shure SC35C with NOS stylus. Goldring G820 with NOS stylus. Shure M55E with NOS stylus.
CD Player: Audiocom-modified Sony X-777ES/DAS-R1 DAC.
Tape Deck: Tandberg TCD 310, fully restored and recalibrated as new by RDE, plus upgraded with heads from the TCD-420a. Also with matching TM4 Norway microphones.
Preamps: Heavily-modified Croft Charisma-X. Power Amps: Tube Distinctions Copper Amp, fitted with Tungsol KT-150s. Quad 306.
Cables & Sundries: Mark Grant HDX1 interconnects and digital coaxial cable, plus Mark Grant 6mm UP-LCOFC Van Damme speaker cable. MCRU 'Ultimate' mains leads. Lehmann clone headphone amp with vintage Koss PRO-4AAA headphones.
Tube Distinctions digital noise filter. VPI HW16.5 record cleaning machine.
Speakers: Tannoy 15MGs in Lockwood cabinets with modified crossovers. 1967 Celestion Ditton 15.
Site Owner/Administrator
Location: Wrexham, North Wales, UK
Posts: 110,479
I'm AudioAl'sArbiterForPISHANTO.
That's really interesting, Dunc. Ian's going to send you a text, I think, but if you're up for a sesh tomorrow, I'm bringing the Paul Hynes PSU over to his, so we can do some comparisonsOriginally Posted by tubehunter
Prior to my last post regarding power supplies for the Pi.
I have just put this together and sound quality has improved over the stock smps.
There seems a more natural relaxed quality to the sound so probably worth doing, for a cost of around £30.
Marco.
Main System
Turntable: Heavily-modified Technics SL-1210MK5G [Mike New bearing/ETP platter/Paul Hynes SR7 PSU & regulator mods]. Funk Firm APM Achromat with Nagaoka GL-601 Crystal Record Weight. Isonoe feet & boots. Ortofon RS-212D tonearm with Denon DL-103GL, in a Denon PCL-300 headshell, fitted with Funk Firm Houdini and Kondo SL-115 pure-silver cartridge leads.
Paul Hynes MC head amp/SR5 PSU. Also modded Lentek head amp and Denon AU-310 SUT.
Other Cartridges: Nippon Columbia (NOS 1987) Denon DL-103. USA-made Shure SC35C with NOS stylus. Goldring G820 with NOS stylus. Shure M55E with NOS stylus.
CD Player: Audiocom-modified Sony X-777ES/DAS-R1 DAC.
Tape Deck: Tandberg TCD 310, fully restored and recalibrated as new by RDE, plus upgraded with heads from the TCD-420a. Also with matching TM4 Norway microphones.
Preamps: Heavily-modified Croft Charisma-X. Power Amps: Tube Distinctions Copper Amp, fitted with Tungsol KT-150s. Quad 306.
Cables & Sundries: Mark Grant HDX1 interconnects and digital coaxial cable, plus Mark Grant 6mm UP-LCOFC Van Damme speaker cable. MCRU 'Ultimate' mains leads. Lehmann clone headphone amp with vintage Koss PRO-4AAA headphones.
Tube Distinctions digital noise filter. VPI HW16.5 record cleaning machine.
Speakers: Tannoy 15MGs in Lockwood cabinets with modified crossovers. 1967 Celestion Ditton 15.
Senior Member
Location: Down South
Posts: 2,411
I'm Neal.
How hot are those LM317 getting? You may find dropping the voltage a bit helps by using a 9v Tx...Prior to my last post regarding power supplies for the Pi.
I have just put this together and sound quality has improved over the stock smps.
There seems a more natural relaxed quality to the sound so probably worth doing, for a cost of around £30.
Listening in a Foo free Zone...
Only a Sith deals in absolutes.
Grand Veteran
Location: Happy Cheshire
Posts: 737
I'm Duncan.
Marco I'll see u tomorrow....
Regarding the regulators they are bolted to the floor of my aluminium PiPre case.
Don't even get warm.
I believe a tracking preregulator likes a bit of headroom with voltage.
The Pi with Iqaudio pidac+ attached only consumes 330mA's when playing, with a Usb stick inserted this goes up to 412mA's.
Hang a couple of hard drives off this and it's going to increase considerably.
Last edited by tubehunter; 01-05-2015 at 08:18.
Site Owner/Administrator
Location: Wrexham, North Wales, UK
Posts: 110,479
I'm AudioAl'sArbiterForPISHANTO.
Look forward to it, mate. Should be an interesting one
Marco.
Main System
Turntable: Heavily-modified Technics SL-1210MK5G [Mike New bearing/ETP platter/Paul Hynes SR7 PSU & regulator mods]. Funk Firm APM Achromat with Nagaoka GL-601 Crystal Record Weight. Isonoe feet & boots. Ortofon RS-212D tonearm with Denon DL-103GL, in a Denon PCL-300 headshell, fitted with Funk Firm Houdini and Kondo SL-115 pure-silver cartridge leads.
Paul Hynes MC head amp/SR5 PSU. Also modded Lentek head amp and Denon AU-310 SUT.
Other Cartridges: Nippon Columbia (NOS 1987) Denon DL-103. USA-made Shure SC35C with NOS stylus. Goldring G820 with NOS stylus. Shure M55E with NOS stylus.
CD Player: Audiocom-modified Sony X-777ES/DAS-R1 DAC.
Tape Deck: Tandberg TCD 310, fully restored and recalibrated as new by RDE, plus upgraded with heads from the TCD-420a. Also with matching TM4 Norway microphones.
Preamps: Heavily-modified Croft Charisma-X. Power Amps: Tube Distinctions Copper Amp, fitted with Tungsol KT-150s. Quad 306.
Cables & Sundries: Mark Grant HDX1 interconnects and digital coaxial cable, plus Mark Grant 6mm UP-LCOFC Van Damme speaker cable. MCRU 'Ultimate' mains leads. Lehmann clone headphone amp with vintage Koss PRO-4AAA headphones.
Tube Distinctions digital noise filter. VPI HW16.5 record cleaning machine.
Speakers: Tannoy 15MGs in Lockwood cabinets with modified crossovers. 1967 Celestion Ditton 15.
Grand Veteran
Location: Happy Cheshire
Posts: 737
I'm Duncan.
I'll also bring a couple SD cards with Runeaudio, Moode and Volumio pre configured so we can compare them.
Site Owner/Administrator
Location: Wrexham, North Wales, UK
Posts: 110,479
I'm AudioAl'sArbiterForPISHANTO.
Cool. Should I also bring my Pi, then, and if I prefer Moode (which I think you posted a screenshot of before), you can install that instead on my Pi?
Marco.
Main System
Turntable: Heavily-modified Technics SL-1210MK5G [Mike New bearing/ETP platter/Paul Hynes SR7 PSU & regulator mods]. Funk Firm APM Achromat with Nagaoka GL-601 Crystal Record Weight. Isonoe feet & boots. Ortofon RS-212D tonearm with Denon DL-103GL, in a Denon PCL-300 headshell, fitted with Funk Firm Houdini and Kondo SL-115 pure-silver cartridge leads.
Paul Hynes MC head amp/SR5 PSU. Also modded Lentek head amp and Denon AU-310 SUT.
Other Cartridges: Nippon Columbia (NOS 1987) Denon DL-103. USA-made Shure SC35C with NOS stylus. Goldring G820 with NOS stylus. Shure M55E with NOS stylus.
CD Player: Audiocom-modified Sony X-777ES/DAS-R1 DAC.
Tape Deck: Tandberg TCD 310, fully restored and recalibrated as new by RDE, plus upgraded with heads from the TCD-420a. Also with matching TM4 Norway microphones.
Preamps: Heavily-modified Croft Charisma-X. Power Amps: Tube Distinctions Copper Amp, fitted with Tungsol KT-150s. Quad 306.
Cables & Sundries: Mark Grant HDX1 interconnects and digital coaxial cable, plus Mark Grant 6mm UP-LCOFC Van Damme speaker cable. MCRU 'Ultimate' mains leads. Lehmann clone headphone amp with vintage Koss PRO-4AAA headphones.
Tube Distinctions digital noise filter. VPI HW16.5 record cleaning machine.
Speakers: Tannoy 15MGs in Lockwood cabinets with modified crossovers. 1967 Celestion Ditton 15.
Posting Permissions
Reply With Quote
