Quad Help!

[spendorman]

Quad service info

[symon]

OK, I'll give that a go. Does it matter what the probe is made from?

[spendorman]

OK, I'll give that a go. Does it matter what the probe is made from?

Never needed to do this, I suppose something like a plastic knitting needle could be used, sharpened as shown. However, be careful that it does not break off leaving a bit that will be difficult to remove and don't bend the contacts much.

I give no guarantee!!

[symon]

no change

[symon]

What I don't understand is why it can be so nearly there when payed on the Radio input with both mono buttons pushed in, yet be so far from perfect when the stereo button is used.

[spendorman]

What I don't understand is why it can be so nearly there when payed on the Radio input with both mono buttons pushed in, yet be so far from perfect when the stereo button is used.

That must be a clue.

Perhaps someone else can come up with a suggestion.

[symon]

I'm at a loss now. I don't know enough to fiddle.

The other clue is that I haven't got the tt playing properly through the set up yet.

[spendorman]

What is the TT? Does it work through another amp?

[Dave Cawley]

The probe should of course be metal of any type. But this doesn't rule out incorrect wiring, which for a £20 pound bet to charity I'll put my hat on.

Dave

[symon]

The tt is a Technics sl-3, with an mm cart. Yes, it does work through the Denon.

When you say incorrect wiring, what do you mean? By me or in the Quads? It has been working prior to my getting it. Although, a p hone call over the next day or two will be made to confirm lots of detail I don't have at the moment.