/Mike
Senior Member
Location: Falun, Sweden
Posts: 2,243
I'm Mike.
/Mike
Senior Member
Location: Eastern, US
Posts: 2,027
I'm afesteringvinylphile.
It's gonna bewhen you finish. Then you just have to figure what record to play first when you get it back.
Lyrics are the ramblings of man, sometimes inspired by The Creator, most often, not.
But music (melodies, harmonies, rhythms), that's God stuff.
Always was. Always will be.
One of the biggest lies ever told was that only certain kinds of people should listen to certain kinds of music.
(silent) VINYL LP SLIDESHOWS
Trade: Wakefield Turntables
Location: Yorkshire
Posts: 9,788
I'm Andrew.
The 301 will also be living with a SME 3012. My SME 3012 is also being fettled by J7 at Audio Origami. You'll be pleased to know that there isnt an ounce of silver in this system, its an all copper affair. Unlike the 1210 setup of pure silver cabling etc. I'll be on the look out for some decent speaker cable, and maybe some new valve amps
SS
CD Teac VRDS25X(Audiotuned) DECK 1210 Mat Crystal Audio Mods MN Base/Bearing/Platter+Ebony armboard Feet Isonoe PSU Paul Hynes SR7EHD-27XL/DCSXL Ag DC lead/3 Stage Regs/Recap PCB+No Pitch/Strobe/Light ARM SME V(Kondo Ag Rewire&Tags) MC Cadenza Black FGS CABLES Arm Yannis SPD-4 IC Yannis 222 Litz+Ag bullets Power WAR PRE ATC SCA2 SPEAKERS ATC 50ASL STANDS Atacama PHONO Sugden Masterclass PA4 SUT Ortofon ST80SE POWER PSAudio P10
VALVE / MONO
PRE Croft Epoch(Modded) AMP Sondex S100 (Modded) SPEAKERS Tannoy 15"MG+RFC Warwick cabs+ Ref XO + Batpure supertweeters DECK Garrard 301 Mat Teunto Bearings 401(Bastin) Plinth Bamboo Arms 3009/3012 PSU Eagle+Tachometer MC Ag Meister II/FGS + Ortofon SPU MONO CABLES Arm Yannis 420.5 Litz+ SpeakerPC Tripple C+WBT-0681 Ag IC Oyaide FTVS-510 AgWBT 0110Ag Phonostages Paradise(4 Box Mega-Modded) / Croft Musicmaker
Trade: Wakefield Turntables
Location: Yorkshire
Posts: 9,788
I'm Andrew.
it's coming home tomorrow, doms finished the bits I couldn't do. Pics to follow in next few days
SS
CD Teac VRDS25X(Audiotuned) DECK 1210 Mat Crystal Audio Mods MN Base/Bearing/Platter+Ebony armboard Feet Isonoe PSU Paul Hynes SR7EHD-27XL/DCSXL Ag DC lead/3 Stage Regs/Recap PCB+No Pitch/Strobe/Light ARM SME V(Kondo Ag Rewire&Tags) MC Cadenza Black FGS CABLES Arm Yannis SPD-4 IC Yannis 222 Litz+Ag bullets Power WAR PRE ATC SCA2 SPEAKERS ATC 50ASL STANDS Atacama PHONO Sugden Masterclass PA4 SUT Ortofon ST80SE POWER PSAudio P10
VALVE / MONO
PRE Croft Epoch(Modded) AMP Sondex S100 (Modded) SPEAKERS Tannoy 15"MG+RFC Warwick cabs+ Ref XO + Batpure supertweeters DECK Garrard 301 Mat Teunto Bearings 401(Bastin) Plinth Bamboo Arms 3009/3012 PSU Eagle+Tachometer MC Ag Meister II/FGS + Ortofon SPU MONO CABLES Arm Yannis 420.5 Litz+ SpeakerPC Tripple C+WBT-0681 Ag IC Oyaide FTVS-510 AgWBT 0110Ag Phonostages Paradise(4 Box Mega-Modded) / Croft Musicmaker
Double Daftee
Location: Essex, UK
Posts: 3,439
I'm Andy.
System; Michell Gyrodec SE/ Orbe Clamp/ Gert Pedersen armboard mod/ HR PSU/ SME V / J7 Tonearm cable/Ortofon Cadenza Black// Jez Arkless Turbo nutter B------ /Trichord Dino+
Amplification and loudspeaker set up is at the moment being split into two groups, comprising the following;
1. Same sources as above; SONY TAF-770ES/SONY CDP761E/Cable Talk 3.1 loudspeakercable/ Harbeth Compact7ES2/ Stands
2. Virtue Audio Sensation M451battery PSU, ClarityCaps upgrade/ Sensation M901/Russian PIO caps with Teflon bypass caps upgrade/ JT Dynamic PSU with various tweaks/ Connex Audio 5N Litz loudspeaker cable, Impulse H6 Loudspeakers.
Me so horny- Impulse H6 Horny
Pishanto Specialist & Super-Daftee
Location: Dagenham Essex
Posts: 11,184
I'm Allen.
Now I'm getting all excited as well
[
Trade: Wakefield Turntables
Location: Yorkshire
Posts: 9,788
I'm Andrew.
It's arrived today, will post some pics when I drag it home.
SS
CD Teac VRDS25X(Audiotuned) DECK 1210 Mat Crystal Audio Mods MN Base/Bearing/Platter+Ebony armboard Feet Isonoe PSU Paul Hynes SR7EHD-27XL/DCSXL Ag DC lead/3 Stage Regs/Recap PCB+No Pitch/Strobe/Light ARM SME V(Kondo Ag Rewire&Tags) MC Cadenza Black FGS CABLES Arm Yannis SPD-4 IC Yannis 222 Litz+Ag bullets Power WAR PRE ATC SCA2 SPEAKERS ATC 50ASL STANDS Atacama PHONO Sugden Masterclass PA4 SUT Ortofon ST80SE POWER PSAudio P10
VALVE / MONO
PRE Croft Epoch(Modded) AMP Sondex S100 (Modded) SPEAKERS Tannoy 15"MG+RFC Warwick cabs+ Ref XO + Batpure supertweeters DECK Garrard 301 Mat Teunto Bearings 401(Bastin) Plinth Bamboo Arms 3009/3012 PSU Eagle+Tachometer MC Ag Meister II/FGS + Ortofon SPU MONO CABLES Arm Yannis 420.5 Litz+ SpeakerPC Tripple C+WBT-0681 Ag IC Oyaide FTVS-510 AgWBT 0110Ag Phonostages Paradise(4 Box Mega-Modded) / Croft Musicmaker
Trade: Wakefield Turntables
Location: Yorkshire
Posts: 9,788
I'm Andrew.
OK, the SME 3012 has been fully fettled and restored, heres whats been done
strip and clean both knife edge and horizontal bearings
strip and refill arm cue with silicon
replace rear stub rubbers x 2 rebuild and check
clean arm tube and arm pillar area from oxidised marks
rewire arm tube with cardas 33ga ofc coper litz
fit extra cardas gold 5 pin base detachable connector
Quite a lot
The 301 is now sitting on my bedroom floor from Northwest analouge, I fitted a power lead today. It works a treat and is silent as death
I await my koetsu black. I will be making a temporary plinth until I get my stone one made. Then I'll have to make a custom rack (maybe next year!).
SS
CD Teac VRDS25X(Audiotuned) DECK 1210 Mat Crystal Audio Mods MN Base/Bearing/Platter+Ebony armboard Feet Isonoe PSU Paul Hynes SR7EHD-27XL/DCSXL Ag DC lead/3 Stage Regs/Recap PCB+No Pitch/Strobe/Light ARM SME V(Kondo Ag Rewire&Tags) MC Cadenza Black FGS CABLES Arm Yannis SPD-4 IC Yannis 222 Litz+Ag bullets Power WAR PRE ATC SCA2 SPEAKERS ATC 50ASL STANDS Atacama PHONO Sugden Masterclass PA4 SUT Ortofon ST80SE POWER PSAudio P10
VALVE / MONO
PRE Croft Epoch(Modded) AMP Sondex S100 (Modded) SPEAKERS Tannoy 15"MG+RFC Warwick cabs+ Ref XO + Batpure supertweeters DECK Garrard 301 Mat Teunto Bearings 401(Bastin) Plinth Bamboo Arms 3009/3012 PSU Eagle+Tachometer MC Ag Meister II/FGS + Ortofon SPU MONO CABLES Arm Yannis 420.5 Litz+ SpeakerPC Tripple C+WBT-0681 Ag IC Oyaide FTVS-510 AgWBT 0110Ag Phonostages Paradise(4 Box Mega-Modded) / Croft Musicmaker
Trade: Wakefield Turntables
Location: Yorkshire
Posts: 9,788
I'm Andrew.
ok, here is the first pictures of the 301 and the SME 3012 back from Northwest analouge and audio origami. Not much to look at but I intend mounting them in a temporary plinth by the end of the week.
SS
CD Teac VRDS25X(Audiotuned) DECK 1210 Mat Crystal Audio Mods MN Base/Bearing/Platter+Ebony armboard Feet Isonoe PSU Paul Hynes SR7EHD-27XL/DCSXL Ag DC lead/3 Stage Regs/Recap PCB+No Pitch/Strobe/Light ARM SME V(Kondo Ag Rewire&Tags) MC Cadenza Black FGS CABLES Arm Yannis SPD-4 IC Yannis 222 Litz+Ag bullets Power WAR PRE ATC SCA2 SPEAKERS ATC 50ASL STANDS Atacama PHONO Sugden Masterclass PA4 SUT Ortofon ST80SE POWER PSAudio P10
VALVE / MONO
PRE Croft Epoch(Modded) AMP Sondex S100 (Modded) SPEAKERS Tannoy 15"MG+RFC Warwick cabs+ Ref XO + Batpure supertweeters DECK Garrard 301 Mat Teunto Bearings 401(Bastin) Plinth Bamboo Arms 3009/3012 PSU Eagle+Tachometer MC Ag Meister II/FGS + Ortofon SPU MONO CABLES Arm Yannis 420.5 Litz+ SpeakerPC Tripple C+WBT-0681 Ag IC Oyaide FTVS-510 AgWBT 0110Ag Phonostages Paradise(4 Box Mega-Modded) / Croft Musicmaker
Senior Member
Location: Falun, Sweden
Posts: 2,243
I'm Mike.
Looks to be beautifully restored to mint cond! I'm sure youre kind of eager to hear it now, aren't you?
Looking forward to following the tt's path to glory!
Regards /Mike
Posting Permissions
Reply With Quote
