Regarding cross overs- i have gleaned a little from the Yahoo group and a few other sources so am on the right track i think-i have a schematic for a MG 15"for the Autograph which may be ok for the Westminster, component changes are changing the cap on the input to hf section to 10uf, changing the 50 ohm resistor to 100 ohms and the 20 ohm resistor to 10 ohms, another important change seems to be moving the drivers tap of the autoformer to the lowest rather than the second lowest tap which steps the tweeter level up more to match the efficiency of the woofer with horn loading to its full range-i will work through it with Nick and see how we get on-the drivers turned up yesterday so measured out and cut new carriers for them so the cross over is the last piece if the jigsaw.

Any other ideas for tweaking the 385 cross over for use in the Westminster.

Dave-what did you do for cross over duties?

Ta Si.