Valves, I think I'm starting to understand what the fuss is about.

[HighFidelityGuy]

Dave, I've found the Takman resistors very good. Cheap too.

Thanks Ali. I've used them before and found them to be good. I'm actually using a couple in this project as I couldn't get Kiwame's in a certain value. I'm also using some tantalum resistors in another place for the same reason.

I'd go for the Solens out of the two, they are a little more specialised where as the Evox-Rifa are more general purpose as far as i'm aware

I'm sure there are a bucket full more out there though so take your time. Whilst it won't have any audio signal passing directly through it it still one of the most important caps in the amp keeping the voltage on the front end stable.

Thanks Mark. I've ordered some 0.6uF Solen caps as they were the biggest that would fit on the back of the PCB. I think they'll be easier to fit than the Evox ones as well.

I've now got all of the components mounted other than the few power supply related caps that I'm ordering now and the parts relating to the heater supply. The heater supply is proving tricky as there's not much room to mount the extra components required for the Schottky diode upgrade. So I'm just trying to puzzle that out. I'll post some photo's ASAP but I seem to have mis-placed my camera at the moment.