Turned me Suggie on, nothing, wtf? A21s-I, so not an old model.
Senior Member
Location: Brighton, UK.
Posts: 3,193
I'm Mike.
Suggies croaked it
Turned me Suggie on, nothing, wtf? A21s-I, so not an old model.
Current system 1210 GR. CDP - Meridian G08. Amp -Sugden A21I - Sig. Wharfedale Lintons.
Senior Member
Location: London/Durham
Posts: 7,003
I'm Lawrence.
Checked the fuse?
Sent from my PCT-L29 using Tapatalk
Senior Member
Location: Brighton, UK.
Posts: 3,193
I'm Mike.
in the plug? I just used another plug, sameOriginally Posted by Lawrence001
Current system 1210 GR. CDP - Meridian G08. Amp -Sugden A21I - Sig. Wharfedale Lintons.
Senior Member
Location: London/Durham
Posts: 7,003
I'm Lawrence.
Maybe a fuse inside?
Sent from my PCT-L29 using Tapatalk
Senior Member
Location: Brighton, UK.
Posts: 3,193
I'm Mike.
fuck knows, where do I look
Current system 1210 GR. CDP - Meridian G08. Amp -Sugden A21I - Sig. Wharfedale Lintons.
Fount Master & Moderator
Location: Essex
Posts: 33,112
I'm openingabottleofwine.
Is it a Sugden A21se Signature? If so, the fuse is under the mains connector on the rear of the amplifier, to the right of the speaker connections.
Barry
Don McCorleone
Location: Galashiels
Posts: 13,740
I'm inthescottishmafia.
There'll likely be fuses on the circuit board inside also, check those if the others are ok.
“Music has always been a matter of energy to me, a question of fuel. Sentimental people call it inspiration, but what they really mean is fuel. I have always needed fuel. I am a serious consumer. On some nights I still believe that a car with the gas needle on empty can run about fifty more miles if you have the right music very loud on the radio”
Hunter S Thompson
Senior Member
Location: Brighton, UK.
Posts: 3,193
I'm Mike.
Thanks, its the a21l-s or something, but the fuse below the socket, its blown , i replaced it but it just keeps on blowing
Current system 1210 GR. CDP - Meridian G08. Amp -Sugden A21I - Sig. Wharfedale Lintons.
Fount Master & Moderator
Location: Essex
Posts: 33,112
I'm openingabottleofwine.
Yes, there are two 2.5A quick-blow fuses on each of the power amplifier boards.
They are there to protect the amplifier power output stages from faults, such as the speaker terminals being short circuited. If any of the fuses have blown, carefully check that there are no stray wires where the speaker cables connect with the speaker terminals of the amplifier. If you simply replace the fuse(s) without finding the cause, the fuses will just blow again and might cause damage to the amp.
Barry
Fount Master & Moderator
Location: Essex
Posts: 33,112
I'm openingabottleofwine.
That sounds like there is a problem with the power supply. It could be a number of things: faulty mains transformer; faulty diodes or bridge rectifier, or even one or more of the smoothing capacitors.
Is there a audio dealer near you who could look at it and diagnose the problem?
Barry
Posting Permissions
Reply With Quote