Hi All so after Truepoint making and selling a lot of the pylons, there was one complaint received, which is the result of fiddling with them , and not fitting them properly, putting the o rings in wrong and using thinner than needed, then removing of the bearings in the pylons bases,, also removing the pads in the pylons which the suspension sits on , to get a realy bad result, the reason the pylons are stiff to use is the orings and not elastic bungee chord, they will no longer bounce all over the place , the stiffer the less movement of the chassis, the center bush is there to help the chassis from moving ,
they are not single point contact any more?? ,The nut with the o rings on sit of the original single point contact adjuster with the bearing inside,
the microphone effect has always been part of this deck , from the design of the deck you will always get some sort of microphone effect as the aluminium chassis has no where else to send the frequences to,
it has and continues to be a bugbear to try and get rid of that effect , but the only way is to use a seperate arm pod and not clamp the arm directly to the chassis
he has continued with a app of to measure the wow , which means nothing as he has changed the original supplied pylons, to his pylons, and not mine, Truepoint have offered him a full refund, i wait to see what the reply is from him , but out of a lot of sets this is the only one,

pete