Deaf Row!

[walpurgis]

Can you not reverse the panel - or is the satin finish on one face only?

The back was scratched, but they sent a replacement Barry, so all is good.

[Edward]

Looks like it's goodbye to these. Just been sold on ebay. Had them since 2013. They sound fabulous, among the very top sounding Tannoys I've ever heard and that's all the classics near enough.

Hope the sale completes ok and the buyer does not muck you around Geoff.

[walpurgis]

Hope the sale completes ok and the buyer does not muck you around Geoff.

Fingers crossed. The buyer has good feedback.

[dantheman91]

What are you replacing the tannoys with?

[walpurgis]

What are you replacing the tannoys with?

I've also got smaller Tannoys and my little Ruarks and loads of interesting drive units. There might be a horn speaker project soon .

[dantheman91]

I've also got smaller Tannoys and my little Ruarks and loads of interesting drive units. There might be a horn speaker project soon .

Master plan interesting. ☺����

[walpurgis]

Just bought these KEF Q3 cabinets off ebay for a bit of fun. It'll allow me to test some drivers I have knocking about.

[walpurgis]

Tonight's project.

A pair of Mission 762 speakers with completely rotted foam cone surrounds. Got some rubber (not foam) surrounds that don't fit due to the originals having a very narrow roll so I've trimmed about 4mm off the cone all round to make them fit. It'll work and I'll have these up and running soon.

Don't care about originality on these as long as they work.

Finally got these done. Sounding very decent actually. I seem to have mislaid two driver mounting screws, I'll rummage for replacements.

[walpurgis]

Had a box delivered this afternoon.

[Firebottle]

Yah!
When you've checked them out and found out how good they are you may want to slow the fan down to make it quieter.
Wire a 180 ohm resistor in series with the fan. The case splits left and right btw.