Cheap upgrade for michell gyro

[gwernaffield]

I have been asked about the acrylic spacer that you can buy off eBay and drill your own holes to make it fit ,, it was 114mm diameter 12mm thick and with a 85mm hole in the center ,, you need to make the gaskets from rubber and buy the longer bolts, all off eBay ,, I do not make them or supply them ,,

how ever I am looking at dining a full SME arm board out of Acrylic ,,which will be on piece and will replace the spacer and the Michell arm board ,, with the use of one piece proper arm board , ,which will be started tomorrow,,





using the Michell arm board as a template, and then getting the rear counter bored to 85mm diameter fitting a gasket to the base,, to use a damper ,, i will let you know the cost, at a later date,,

The pylons are still made, The O rings that Steve had were replaced, this was because the wrong shore rating had been sent by mistake,, I had somehow ended up with 90 shore and not the 70 ,, he is now happy ,, and continues to enjoy the Gyro he owns,,
ATB
pete