Quote Originally Posted by Light Dependant Resistor View Post
Hi Chris
If you remove the outer platter, the inner platter despite raising up a bit can be examined for any point that is touching
It suggests the motor area, I seem to recall two screws that get close to moving parts near the motor. It should show up
where it is just touching, if you rotate the inner platter. Hope that helps.
Hi Chris, unfortunately (or maybe fortunately?) it is not in contact with any part of the motor or the screws. (I'd imagine this would be caused by a lack of upward force from the springs?).

Again - wish it was a quick fix like this!!

Cheers anyway