Yellow was what I was thinking, yellow or orange.
Current Lash Up:
TEAC VRDS 701T > Sony TAE1000ESD > Krell KSA50S > JM Labs Focal Electra 926.
Turntable; Rega p8
Cartridge; Alpheta mc
Phono Stage; Rega Aria, Bigbottle 3 mm/mc
Amplifier; Rega Elicit
Speakers; Rega Rx3
Hi Steve, How are you. Good stuff going on with the Dcb1. I heard Olis the other day into the amazing Krell KSA 100, I was so impressed I have been looking at Krell's this morning. Plenty about for around £1500-£2000 so seem good value. Only problem is the SIZE!
Going back to the Dcb1 - dual mono does sound a good choice as you will get excellent signal separation. Do you put this through a single Khozmo?
Main system : VPI Scout 1.1 / JMW 9T / 2M Black / Croft 25R+ / Croft 7 / Heco Celan GT 702
Second System : Goldring Lenco GL75 / AT95EX / Pioneer SX590 / Spendor SP2
Hi James
You have the coice of one or two Khozmo.
I personally chose 1 because both channels are separate
No connection in any way
The size of the Krell is an issue for me too as i live in a small adapted bungalow,but i will get one in somehow
Steve..
Turntable; Rega p8
Cartridge; Alpheta mc
Phono Stage; Rega Aria, Bigbottle 3 mm/mc
Amplifier; Rega Elicit
Speakers; Rega Rx3
They're not that big! I live in a little 2 bed terrace and I managed to jam one in somehow. It won't fit in the equipment rack, but then you can't have everything.
Current Lash Up:
TEAC VRDS 701T > Sony TAE1000ESD > Krell KSA50S > JM Labs Focal Electra 926.
Location: KY - Scotland
Posts: 5,495
I'm Mike.
I'm tempted at trying the DCB1 in my system again. I had one before but to me it sounded a bit edgy when driven harder. It sounds like ( pardon the pun ), that this isn't an issue with the ones that I've seen you all build here.
I subsequently found out that the board in the one I had wasn't the best so I'd be keen to try one again as I have a buyer for my Velleman valve pre amp so might be short of a pre soon lol.
Does anyone have one I could borrow? I'll pay post both ways of course.
If I liked it could someone build me one and if so how much would a finished one be?