the problem is the gyro uses the suspension to keep the feet on , i read an old review were they complained the feet caused noise to travel into the chassis, and you could hear if the platform was tapped into the chassis ,
also i was told by a user Aejoker on his gyro if he tapped the chassis he could hear the tap through the speaker , The answer was simple in the end to isolate the small shaft in the split adjuster (upgrade system ) in the Michell pylon , what i did not expect was it works as well with the orbe if you have a split suspension , the older type on the orbe , does not have the feet on the suspension or the new type,
Michell has decoupled the suspension in the orbe , But not on the Gyro , 3 little pads will help stop 90% , it was there when the springs where is use and still there when the new suspension was added due to the Michell design