While I was on a roll I decided to make a PCB for the PSU.
I had half a 160 x 100mm board left over from the regulator project and a pair of PCB's just fit.






Because I am fitting the PSU board in my existing external case it ended up an unusual shape due to space restrictions, but it still follows Jim's schematic. The other board is for my second deck which uses the same case, but it doesn't have the control switches in the roof and the on/off button is in a less restrictive position so there is much more room.

I need to test the output of this next and the regulator when its connected to it, before hooking up to the deck.