Quote Originally Posted by Slideshaker View Post
Hugo,

Just a quick update: 4 'orders' so far, just from the weekend.

Also, just wondered if a 'one-off' was possible? - same basic design, but arm lift cut-out not required and different diameter hole. Thanks.
Off the top of my head and based on my original prototype cost, a one-off would cost at least twice as much, eg most probably £70-£80, not including any anodising which is very expensive indeed for single items.

Thanks for putting the word about. If I can get enough interest for a much larger production run, then I can keep costs reasonable while ensuring that I don't lose any money myself; also I can consider anodising which is cheap enough if done on a large batch. The last run was perilously close to costing me money!