+ Reply to Thread
Page 12 of 23 FirstFirst ... 2101112131422 ... LastLast
Results 111 to 120 of 224

Thread: Going Linear with the Caiman

  1. #111
    Join Date: Jul 2010

    Location: Co Durham

    Posts: 50

    Default

    If you have a passive output, do you need to supply 12 or 15 V at all, do you only require the 5 V for the DAC power rail?
    ''You canna break the laws of Physics Jim"

    Andy.

  2. #112
    Join Date: May 2008

    Location: Surrey

    Posts: 7,219
    I'm Rob.

    Default

    It the PS caps are removed should jumpers be put in their place?

    Having given it some thought, I would assume not.
    Last edited by Puffin; 03-08-2010 at 10:29.
    Buy Bose...And get your parking validated!.

    https://youtu.be/ZCBe7-6rw4M

    No Highs...No Lows....It Must Be Bose!

  3. #113
    Join Date: Mar 2008

    Location: Galashiels

    Posts: 14,031
    I'm inthescottishmafia.

    Default

    Quote Originally Posted by OLED View Post
    If you have a passive output, do you need to supply 12 or 15 V at all, do you only require the 5 V for the DAC power rail?
    Well that was my thought,to try feeding the dac with it's own regulated supply.These are pretty good supplies I've got I think,low ripple.

  4. #114
    leo's Avatar
    leo is offline Circuit Junkie & DIY Room Forum Leader
    Join Date: Jan 2008

    Location: Notts UK

    Posts: 1,804

    Default

    Majority of dac and receiver chips I've tried tended to be quite sensitive to the quality of the supply just as much as the analogue sections, some are much more picky than others so its worth going for the best you can if going to the trouble of doing other various mods too imo
    Cheers,
    Leo

  5. #115
    Join Date: Mar 2009

    Location: Sheffield, UK

    Posts: 1,307
    I'm Dave.

    Default

    I'd agree with that.
    I compared my linear supply to the original Caiman supply on my Caiman that has Murata regs and I could definitely hear an improvement using the linear supply. I could hear more subtle detail in the background and the noise floor seemed to be lowered. I guess the linear supply must have better signal to noise ratio.

    The improvements were subtle though and I'm not entirely sure they were worth the money I spent but I think it's worth trying the Maplin CB radio supply Stan recommended.
    Source: Apple TV 4K - DAC: Beresford Bushmaster Mk II - Preamp: CI AudioPLC-1 Mk II - Power Amps: Musical Fidelity 550K mono blocks - Speakers: Wharfedale Opus 3 - Cables: Mark Grant etc - Misc: Belkin PF30 mains filters.

  6. #116
    Join Date: Oct 2008

    Location: Glasgowshire

    Posts: 10,638
    I'm Gary.

    Default

    Hey Dave,
    your linear PSU for the Caiman, was it a diy job with Teddyregs etc?

    ta.
    Gaz.
    Ok with not having it on Betamax nowadays

  7. #117
    Join Date: Mar 2009

    Location: Sheffield, UK

    Posts: 1,307
    I'm Dave.

    Default

    Quote Originally Posted by Gazjam View Post
    Hey Dave,
    your linear PSU for the Caiman, was it a diy job with Teddyregs etc?

    ta.
    Gaz.
    Yep, SuperTeddy reg, 100VA tranny, HexFred bridge rectifier, 22,000uF Mundorf smoothing cap etc.

    Here's a not very good photo of it before I'd finished bolting it all together:

    Source: Apple TV 4K - DAC: Beresford Bushmaster Mk II - Preamp: CI AudioPLC-1 Mk II - Power Amps: Musical Fidelity 550K mono blocks - Speakers: Wharfedale Opus 3 - Cables: Mark Grant etc - Misc: Belkin PF30 mains filters.

  8. #118
    Join Date: Oct 2008

    Location: Glasgowshire

    Posts: 10,638
    I'm Gary.

    Default

    Thanks Dave!

    I'll have a bash with the Maplins one..jeez, just checked their website, have you seen their returns policy!?

    basically you cant return it unless its faulty...then you need to get it "checked" before a refund...hmnn.
    Reckon the Maplins supply is good enough quality?

    ta.
    Ok with not having it on Betamax nowadays

  9. #119
    Join Date: Mar 2008

    Location: Galashiels

    Posts: 14,031
    I'm inthescottishmafia.

    Default

    Leo,I'm already feeding the dac with a regulated linear supply.Do you think there's any mileage in using another linear supply to feed 5v to the dac chip directly?

  10. #120
    Join Date: Mar 2009

    Location: Sheffield, UK

    Posts: 1,307
    I'm Dave.

    Default

    Quote Originally Posted by Gazjam View Post
    Thanks Dave!

    I'll have a bash with the Maplins one..jeez, just checked their website, have you seen their returns policy!?

    basically you cant return it unless its faulty...then you need to get it "checked" before a refund...hmnn.
    Reckon the Maplins supply is good enough quality?

    ta.
    No probs.

    That sounds a bit dodgy of Maplin. I would have thought that contravenes UK distance selling rules where you're entitled to return the item for a full refund (minus shipping) within 7 days of purchase. I thought that was law. It's supposed to protect you against accidentally purchasing an unsuitable product due to you not being able to actually see the item in the flesh. I'd pull them up on this.

    EDIT: Here's a link to the regulations LINK. You want section 3.22 onwards. Basically you have the right to return the item within 7 days of receiving it even if the item is fully working.
    Source: Apple TV 4K - DAC: Beresford Bushmaster Mk II - Preamp: CI AudioPLC-1 Mk II - Power Amps: Musical Fidelity 550K mono blocks - Speakers: Wharfedale Opus 3 - Cables: Mark Grant etc - Misc: Belkin PF30 mains filters.

+ Reply to Thread
Page 12 of 23 FirstFirst ... 2101112131422 ... LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •