Garrard Zero 100 Project

[M6NTL]

Maybe try some silent Coat for damping under platter?

https://www.silentcoat.co.uk/collections/deadening

Thanks for the link...

Sent from my Pixel 7 Pro using Tapatalk

[Wakefield Turntables]

Just been thinking about this. Would it not have been Easier to mill something from non- resonant material?? Careful platter mat selection will damp an extra few db’s as well.

[M6NTL]

Just been thinking about this. Would it not have been Easier to mill something from non- resonant material?? Careful platter mat selection will damp an extra few db’s as well.

Yes, it might indeed. I'll give that some thought...

Sent from my Pixel 7 Pro using Tapatalk

[M6NTL]

Just been thinking about this. Would it not have been Easier to mill something from non- resonant material?? Careful platter mat selection will damp an extra few db’s as well.

May I ask for your recommendations regarding materials?
Is Acrylic a good choice? What about Panzerholz (if I can find some) etc?
And mat on top of the Acrylic? What material, felt, rubber?
Any advice very gratefully received!

Sent from my Pixel 7 Pro using Tapatalk

[Wakefield Turntables]

May I ask for your recommendations regarding materials?
Is Acrylic a good choice? What about Panzerholz (if I can find some) etc?
And mat on top of the Acrylic? What material, felt, rubber?
Any advice very gratefully received!

Sent from my Pixel 7 Pro using Tapatalk

I honestly have no ideas with regards materials for your platter. I think platter mats are a dark art. I remember going through 13 different platter mats before finally settling for Tenuto on my Garrard 301/401. I went through probably the same amount again before using a glass platter mat on my 1210.

[M6NTL]

I honestly have no ideas with regards materials for your platter. I think platter mats are a dark art. I remember going through 13 different platter mats before finally settling for Tenuto on my Garrard 301/401. I went through probably the same amount again before using a glass platter mat on my 1210.

Thanks for the reply!

Sent from my Pixel 7 Pro using Tapatalk

[M6NTL]

Working on the positioning of the Tonearm now - lots of height to gain on the platter!
The cartridge I'm playing with has a hugely bent cantilever, does anyone perchance have an old, worn out, but unbent cartridge I could maybe have super cheap just for setting up purposes at all???

Sent from my Pixel 7 Pro using Tapatalk

[Jimbo]

Can you not lower the tonearm at the rear?

[M6NTL]

A little bit, a few millimetres. Unless I cut through the steel plate and recess mount it below.
But it doesn't matter - I'm happy to build up the height (and mass) of the platter with thick black acrylic...

Sent from my Pixel 7 Pro using Tapatalk

[Jimbo]

A little bit, a few millimetres. Unless I cut through the steel plate and recess mount it below.
But it doesn't matter - I'm happy to build up the height (and mass) of the platter with thick black acrylic...

Sent from my Pixel 7 Pro using Tapatalk

You will need to build that up a fair bit but more mass maybe a good thing. I know some of the Lenco GL75 enthusiasts stack double platters to get a bit of mass and height. Just need to engineer a nice long spindle then?