Ian
http://www.hifisounds.co.uk
Photo bucket - loads of mods!
SL1200- DIY PSU- DIY FET int regs-Denon DL103 by Expert Stylus Company on Isokenetic stabiliser & Sumiko HS-12 shell- Achromat - Isonoe feet, Meridian 200 Phono satge, Junson JA-88D, Audio Aero Capitole CD/ DAC, extreme modified Marantz SA7001, Squeezebox Touch modded to death!, Focal 826WSE- Kimber 8TC, Kimber and CAT5 attenuated DIY Interconnects, Kimber mains
"Leave Nothing as Standard"
Since it is still the new year and you bastard pommies keep on winning, I will give you both less 5%
Ian
http://www.hifisounds.co.uk
Photo bucket - loads of mods!
SL1200- DIY PSU- DIY FET int regs-Denon DL103 by Expert Stylus Company on Isokenetic stabiliser & Sumiko HS-12 shell- Achromat - Isonoe feet, Meridian 200 Phono satge, Junson JA-88D, Audio Aero Capitole CD/ DAC, extreme modified Marantz SA7001, Squeezebox Touch modded to death!, Focal 826WSE- Kimber 8TC, Kimber and CAT5 attenuated DIY Interconnects, Kimber mains
"Leave Nothing as Standard"
Forget the new house! think of the fantastic sound quality you will achieve.
Ian
http://www.hifisounds.co.uk
Photo bucket - loads of mods!
SL1200- DIY PSU- DIY FET int regs-Denon DL103 by Expert Stylus Company on Isokenetic stabiliser & Sumiko HS-12 shell- Achromat - Isonoe feet, Meridian 200 Phono satge, Junson JA-88D, Audio Aero Capitole CD/ DAC, extreme modified Marantz SA7001, Squeezebox Touch modded to death!, Focal 826WSE- Kimber 8TC, Kimber and CAT5 attenuated DIY Interconnects, Kimber mains
"Leave Nothing as Standard"
Mike, I've just put my Transfiguration Axia on ebay with no reserve in an effort to raise funds for your bearing... It's only a matter of time now.
Richard.
Location: Lisbon
Posts: 55
I'm Will.
I've been wondering about doing this, but I'm not sure I can be bothered! I've not noticed any problems with it attached as per the Timestep instructions. What would the reason be for changing it - is it dangerous as is or perhaps there would be some performance benefit?
There is a mild performance benefit, but this is dependent on how well resolving your system is. For completeness and the best possible performance, I would make the change to the bottom-left PCB corner.