WTD LP12 armboard template for SME3009 ?? I have been messing about with a homemade one but not convinced I have the dimensions correct...
Location: Powys, Wales
Posts: 334
I'm Sandy.
WTD LP12 armboard template for SME3009 ?? I have been messing about with a homemade one but not convinced I have the dimensions correct...
Google it, there are several dimensioned drgs of the SME mount, I used one when I designed my Mission 774 custom base/mount as it uses the SME bolt pattern.
These old drgs are usually in inches, but I'm sure you can use a calculator.
Or are you after the pivot to spindle distance? (Not the mount/cut out pattern).
There are several versions of the 3009, all but the original series II are listed on vinyl engine for S2P distance.
https://www.vinylengine.com/tonearm_...mlo=&amhi=&cw=
Hope that helps
Location: Powys, Wales
Posts: 334
I'm Sandy.
Thank you kindly...