I am just wondering if there are any fellow Hana ML users here who could perhaps give me a little advice? I am just wondering what the optimum impedance settings and gain settings are best with this cartridge. Any tips welcome.
I am just wondering if there are any fellow Hana ML users here who could perhaps give me a little advice? I am just wondering what the optimum impedance settings and gain settings are best with this cartridge. Any tips welcome.
Hi Steve, looking at the specs I would say 100 ohm load to start, you could try more afterwards.
Output is 0.4mV so you need a gain setting of 60dB or a bit more. What is you phono stage?
I love Hendrix for so many reasons. He was so much more than just a blues guitarist - he played damn well any kind of guitar he wanted. In fact I'm not sure if he even played the guitar - he played music. - Stevie Ray Vaughan
Location: KY - Scotland
Posts: 5,470
I'm Mike.
ML needs 100 + if I remember right
I have my ML set at 100 ohms and 70db on my Trichord Diablo and i have to say it sounds alright
Location: Dunblane
Posts: 528
I'm Steve.
Hi Roger
I run mine on my Rega P8 through a Cyrus Signature phono amp at 60db and 330ohms.
Regards Steve
Funkfirm Little Super Deck with F5 arm
Audio Technica AT33sa
Vertere Phono 1
Naim Supernait 2
Niam Allae speaker