SS
CD Teac VRDS25X(Audiotuned) DECK 1210 Mat Crystal Audio Mods MN Base/Bearing/Platter+Ebony armboard Feet Isonoe PSU Paul Hynes SR7EHD-27XL/DCSXL Ag DC lead/3 Stage Regs/Recap PCB+No Pitch/Strobe/Light ARM SME V(Kondo Ag Rewire&Tags) MC Cadenza Black FGS CABLES Arm Yannis SPD-4 IC Yannis 222 Litz+Ag bullets Power WAR PRE ATC SCA2 SPEAKERS ATC 50ASL STANDS Atacama PHONO Sugden Masterclass PA4 SUT Ortofon ST80SE POWER PSAudio P10
VALVE
PRE Croft Epoch(Modded) AMP Sondex S100 (Modded) SPEAKERS Tannoy 15"MG+RFC Warwick cabs+ Ref XO + Batpure supertweeters DECK Garrard 301 Mat Teunto Bearings 401(Bastin) Plinth Bamboo Arms 3009/3012 PSU Eagle+Tachometer MC Ag Meister II/FGS + Ortofon SPU MONO CABLES Arm Yannis 420.5 Litz+ SpeakerPC Tripple C+WBT-0681 Ag IC Oyaide FTVS-510 AgWBT 0110Ag Phonostages Paradise(4 Box Mega-Modded) / Croft Musicmaker
I built a two tier plinth for a 401, 30mm solid oak. Lower plinth supported on sorbothane and the smaller upper plinth with the chassis mounted, coupled to the lower with spikes into flat discs with indents to locate it. Arm pod mounted onto lower plinth. Spikes couple but the mass is almost doubled by the two levels.
My Denon DP80 has a different looking plinth on the same two tier principle on spikes.
Bakoon 13r Denon DP80 Stax UA-70 Shure Ultra 500 in a Martin Bastin body with jico stylus, project ds2 digital Rullit aero 8 field coils in tqwt speakers
Office system, DIY CSS fullrange speakers with aurum cantus G2 ribbons yulong dac Sony STR6055 receiver Jvc QL-A51 direct drive turntable, Leema sub. JVC Z4S cart is in the house
Garage system another Sony receiver, cassette deck
System components are subject to change without warning and at the discretion of the owner.
Location: Petaling Jaya , Malaysia
Posts: 8
I'm Song.
I
Separate arm pod . Can be troublesome to level armpod if your Tonearm tower for VTA adjustment is too tight. I have a Thomas Schick TA on a Reed armpod . Every time I adjust the VTA , my alignment will get shifted
Location: Petaling Jaya , Malaysia
Posts: 8
I'm Song.
Separate Reed arm pod with Thomas Schick Tonearm . VTA adjustment tower is too tight . Everytime I adjust VTA , alignment will shift .
Last edited by audioblazer; 06-07-2021 at 15:42. Reason: Change image