+ Reply to Thread
Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: BT HomeHub 6 power supply

  1. #11
    Join Date: Nov 2010

    Location: Sheffield/Peak District. UK

    Posts: 524
    I'm Richard.


    Quote Originally Posted by Firebottle View Post
    Most of the SMPS adapters supplied with the routers are 'generic' off the shelf, the ratings are over the top usually for the current needed.

    An easy way to tell, does the SMPS get warm? If it is running anywhere near its rating it will definitely get warm.
    In an instance like this I will always measure the actual current the router takes to size an LPSU closer to actual requirement.
    Yes, good point.

    The SMPS is only slightly warm.

    BTW. I see BT call this HomeHub2
    Last edited by Bonky; 30-11-2020 at 16:40.

  2. #12
    Join Date: Jan 2019

    Location: Liverpool

    Posts: 172
    I'm Andrew.


    Just a word of caution make 100% sure that any LPSU you get is at least 230 v (240 V would be better) as many of the China made ones while they will claim they are 230 v they are almost always 220 V . Now if you are powering a DAC or Pi or other item this may not matter as you switch the item on and use it then switch it off . However things like Routers tend to be left on 24/7 and those 220 v units will not only run hot but very likely fail after a few weeks continued use. You need to have a really good quality unit that will not have problems being on all the time and sadly that often means costly .

  3. #13
    Join Date: Jan 2011

    Location: Bristol, UK

    Posts: 279
    I'm Stephen.


    Quote Originally Posted by Stratmangler View Post
    Connection by ethernet or WiFi?
    It is a Pi 2 so ethernet only.

  4. #14
    Join Date: Jan 2011

    Location: Shropshire

    Posts: 12
    I'm Steve.


    I have looked into replacing this device on my BT Home Hub 2 , beware the DC plug is a non standard size not supplied in the iFi power switches.


    DC Right Angle Connector
    Inside Diameter 3.0mm
    Outside Diameter 5.50mm
    Input 230V 0.3A
    Output 12.0V 1.5A

    I would be interested if anyone else has replaced one of these.
    Last edited by rep; 21-12-2020 at 18:53.
    Emancipate yourselves from mental slavery
    None but ourselves can free our minds.

    Living Room :Squeezebox Touch > Caiman > Nait 5i > Kef iQ5

    Garage : Squeezebox 3 Classic > NAD 302 > Tannoy F1 Custom

+ Reply to Thread
Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts