Sme iv on a techie any advice please?

[SiT4]

Looks lovely. Out of interest how doe the SME sound on the Techie ?

[mikeyb]

The Achromat sounds far superior to the Techie rubber mat

[Zoidburg]

Looks lovely. Out of interest how doe the SME sound on the Techie ?

I've no idea yet :-) but I really hope it sounds bloody good.

Sent from my SM-A715F using Tapatalk

[WullieD20]

Achromat (5mm) AND a Houdini (6mm)......should sort it...two birds with one stone, so to speak cause the Houdini will improve the performance of your cart as well....

[The Vinyl Adventure]

The 5mm is being discontinued soon, so you would need to get one while stocks last.

Thats Matt saying that, I asked Arthur he said not, hey ho lol

[CageyH]

I was surprised to be honest.

[Ianmac]

Ben
have you thought about the option of raising the techie platter.
This would need a 6mm plate between the bearing and chassis baseplate and 6mm extensions on the PCB mouting screw holes.
There is a sticky on fitting a MN bearing/ chassis strenghtening plate at the start of techiepedia which will give you a full explanation.
The making of the 6mm plate is not rocket science and the only difficulty I can see is getting 6mm longer self tapping screws to hold the bearing and motor in position
There are other options available for fixing but you would need the help of a friendly engineer.
Only a thought at this stage.
Ian

[chris@panteg]

I used the Oyaide mat, I preferred it to the Achromat, also 5mm.
Another and cheap option is a cartridge carbon fibre spacer for the headshell.
But I've since sold my Technics and SME 309.

[Zoidburg]

Thanks for all the comments and advice folks,I've managed to sort it now.

Sent from my SM-A715F using Tapatalk

[Zoidburg]

For some reason some SME have the curved side of the arm base on top and others on the bottom. Yours like mine is on top which means you loose some ability to drop it down further.

I have tried to slide the arm base off and refit but that could be an option. However I would be very careful as I suspect there are lots of small parts to allow the base to be slid forward and back.

Hope that make sense.

If you google SME IV or V arms photos you will see more clearly.

Thanks again for your comments flapland mate, inspired by your works I removed the collar assembly, inverted it and refitted it which sorted everything perfectly. Cheers again.

Sent from my SM-A715F using Tapatalk