Trade: Magna Audio
Location: The New Forest
Posts: 1,861
I'm Steve.
SME arm fitting armboard
Here's an armboard replication in aluminium. 10mm thick.
From finish to start.
Black lacquer and M3 caphead bolts for SME armbase mounting.
Etch primer phase. This gives a secure base on the aluminium for the top coats of lacquer.
The bare aluminium board. All fitting holes and shaping done
Cut to shape. Alongside the wooden board it will replace
Will be posted off once the lacquer is fully hardened.
System: Turntable : SP10 MKII slate plinth, Custom Ebony tonearm board, Arm : Fidelity Research FR64s, Cartridge : SPU Royal N. SUT : Lundahl 1:13. Phonostage : Icon Audio, Streaming RPi/Kali reclocker -> I2S -> DSP XO / Pre / 4 DAC's : WAF Najda, 5 Poweramps : 3 x EL84 SET's, 2 x D class amps on bass channels, Speakers : 5 way front loaded horn system: 2 X Tapped sub 15" LF drivers / 2 X Exponential mid bass 15" drivers / Tractrix 200Hz mid horns with JBL2482's, / Tractrix 550Hz upper wooden horns with factory refurb'd Vitavox S2's / Raal Lazy Ribbons as high frequency tweeters. Wires: good silver or good copper where best suited. DIY RCM.
Maker of tonearm boards, armpods, Tannoy GRF style speaker cabinets, horn speakers, counterweights and more.
For more information about my creations and products please click below
http://fosworld.wixsite.com/magna-audio & on Instagram https://www.instagram.com/magna_audio/
Posting Permissions
Reply With Quote