Trade: Magna Audio
Location: The New Forest
Posts: 1,864
I'm Steve.
Ebony armboard for SP-10 and Stax tonearm setup
Here's an ebony armboard and fitting job for a gloss black plinthed SP-10.
The thin copper mat, and tall Stax arm and base, meant with the existing MDF veneered armboard was not low enough.
The Stax arm was very interesting. I've not seen one before.
3 interchangeable arm tubes. 2 S shaped and one straight.
Nice setup.
System: Turntable : SP10 MKII slate plinth, Custom Ebony tonearm board, Arm : Fidelity Research FR64s, Cartridge : SPU Royal N. SUT : Lundahl 1:13. Phonostage : Icon Audio, Streaming RPi/Kali reclocker -> I2S -> DSP XO / Pre / 4 DAC's : WAF Najda, 5 Poweramps : 3 x EL84 SET's, 2 x D class amps on bass channels, Speakers : 5 way front loaded horn system: 2 X Tapped sub 15" LF drivers / 2 X Exponential mid bass 15" drivers / Tractrix 200Hz mid horns with JBL2482's, / Tractrix 550Hz upper wooden horns with factory refurb'd Vitavox S2's / Raal Lazy Ribbons as high frequency tweeters. Wires: good silver or good copper where best suited. DIY RCM.
Maker of tonearm boards, armpods, Tannoy GRF style speaker cabinets, horn speakers, counterweights and more.
For more information about my creations and products please click below
http://fosworld.wixsite.com/magna-audio & on Instagram https://www.instagram.com/magna_audio/
Posting Permissions
Reply With Quote