Making a few upgrades for this Sorane SA 1.2 tonearm.
The original armbase didn't allow the arm to go low enough - the armlift pot fouled on the base.
It was also too loose and shallow, so tightening the securing grub screw put it out of alignment.

I've made a close tolerance brass armbase. The arm pillar is now a nice smooth, close fit and much deeper.

The moon shaped cut out to allow the arm to go lower is now in the right place too.





[IMG]https://uploads.tapatalk-cdn.com/20200523/e5521c2d467a6ea282b12ae8aa146c07.jpg[/IMG

Sent from my Pixel XL using Tapatalk