+ Reply to Thread
Results 1 to 5 of 5

Thread: WTB solid state pre to match Sugden A21a

  1. #1
    Join Date: Oct 2014

    Location: Surrey

    Posts: 437
    I'm Graham.

    Default WTB solid state pre to match Sugden A21a

    I am looking for a solid state pre to match a Sugden A21a power amp.* It must have a balance control, MM phono stage and ideally but not essential decent tone controls .* It must be black, full width and sober looking and be in excellent cosmetic condition. I don't need remote control.

    The following specs are for the pre-amp section of the matching A21a integrated so give a good idea of the specs i am looking to get close to:
    .* Input impedance 50K
    .* Input sensitivity 170mV
    .* Output impedance 560ohms
    .* Max output voltage 4 volts

    Here are the specs for the A21a power amp it will be matched with.
    .* Input impedance 50K
    .* Input sensitivity 675mv for max output

    The ballpark budget is 300-500

  2. #2
    Join Date: May 2019

    Location: Belfast

    Posts: 7
    I'm Ruairi.

    Default

    There's a lovely exposure on pfm. Looking for a valve pre to pair with the same amp myself coincidentally

    Sent from my ONEPLUS A6003 using Tapatalk

  3. #3
    Join Date: Oct 2014

    Location: Surrey

    Posts: 437
    I'm Graham.

    Default

    Hi moloe, which Exposure was that? I could only find an MCX which is deffo above my budget ��

  4. #4
    Join Date: May 2019

    Location: Belfast

    Posts: 7
    I'm Ruairi.

    Default

    https://www.pinkfishmedia.net/forum/...xx1-rc.238399/

    Sent from my ONEPLUS A6003 using Tapatalk

  5. #5
    Join Date: Oct 2014

    Location: Surrey

    Posts: 437
    I'm Graham.

    Default

    Thanks, unfortunately no balance control( or mm stage i think). But it fits the bill appearance wise, very black and ahem restrained which would suit the sugden well. ��

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •