Pi 3 +Boss DAC v1.2+ 2PSU for sale

[Jimbo]

bump

[Cycleallday]

Do you know the ampage output from the psu's please and is it consistent for combined use of each output or does use of two outputs half the amps in each ?

Also note they have voltage adjustment - do you know for what range ?

Mel

[Bigman80]

Do you know the ampage output from the psu's please and is it consistent for combined use of each output or does use of two outputs half the amps in each ?

Also note they have voltage adjustment - do you know for what range ?

Mel

The psu's *should* provide 2.5A. Alan (Firebottle) worked that out somehow as I have the same ones that Jim is selling.

As for adjustment, no idea!

[Pepperamip]

I think these have got one 'transformer' per box so using both outputs simultaneously divides the amps between the two but only if used in that specific way.

Seeing as there are two boxes both would be required to avoid insufficient power reaching the rpi in particular (not so much the isolator which has far less draw)

Sent from my CLT-L09 using Tapatalk

[Pepperamip]

Do you know the ampage output from the psu's please and is it consistent for combined use of each output or does use of two outputs half the amps in each ?

Also note they have voltage adjustment - do you know for what range ?

Mel

I'm using a similar one albeit with one output at 16.3 volts for my Segs dorado supply. There's a small adjustment screw inside the box to adjust the voltage.

Obviously make sure its off at the mains when adjusting.

Sent from my CLT-L09 using Tapatalk

[Jimbo]

Both LPSU units are used to power the Pi +Boss. One connected to the Pi and one connected to the Boss board which also powers the Isolator.

[Jimbo]

Bump

[Jimbo]

Bump

[Jimbo]

Bump

[Firebottle]

Do you know the ampage output from the psu's please and is it consistent for combined use of each output or does use of two outputs half the amps in each ?

Also note they have voltage adjustment - do you know for what range ?

Mel

The total current output from one socket or both combined is a maximum of 2.5A.
The adjustment will cover up to 6V I guess, but the max current will be reduced.

Using two individual power supplies gives better sound (cleaner) with this setup.