Moode setup help please

[Bourneendboy]

I have just set up a Pi with an Iqaudio Dac Pro and want to use the onboard headphone amp of the Iqaudio board.
I have used this successfully before with Volumio, but can't seem to get it working with Moode.

If I set the MPD volume to 'hardware' I get full fixed volume, but can't get any sound with 'software' which I assume is what I need.

Getting very frustrated, so any advice would be much appreciated!

Cheers,

Bill

[mikmas]

If I set the MPD volume to 'hardware' I get full fixed volume, but can't get any sound with 'software' which I assume is what I need.

When you set it to 'software' have you checked that the ALSA setting in the main Audio menu is set to 100%?

If it isn't you will get no volume to play from the dial

[Bourneendboy]

When you set it to 'software' have you checked that the ALSA setting in the main Audio menu is set to 100%?

If it isn't you will get no volume to play from the dial

Thanks Mike, I've been a Muppet!

I did have Alsa at 100%, but was trying to use the volume on my laptop rather than using the dial on Moode!

All sorted, many thanks.