+ Reply to Thread
Results 1 to 4 of 4

Thread: Rega tonearm swap ~ simple advice needed please!

  1. #1
    Join Date: Jan 2015

    Location: New Forest

    Posts: 75
    I'm Paul.

    Default Rega tonearm swap ~ simple advice needed please!

    Hi,
    Thanks for looking ...

    I want to swap over an RB250 pillar/collar fixing from a Michell Syncro to a Roksan Radius mk1with a RB100 with 3 point fixing.

    ... Then l want to put the RB100 on the Syncro.

    Advice much appreciated please!
    l guess there's a Rega expert out there?

    Thanks, Paul
    Last edited by Bamby; 18-06-2019 at 14:13.

  2. #2
    Join Date: Apr 2009

    Location: Near Saffron Walden, Essex

    Posts: 6,464
    I'm Dave.

    Default

    Fitting an RB250 to a turntable with the later 3-point fix is just a matter of putting it in't hole and tightening up the screw collar. Geometry is the same.

  3. #3
    Join Date: Jan 2009

    Location: Sheffield - UK

    Posts: 6,471
    I'm Mark.

    Default

    Dave should know as he’s sold enough but, just to iterate, he’s quite right. Going in the other direction you need to add the three screw holes.

    100% Analogue

  4. #4
    Join Date: Jan 2015

    Location: New Forest

    Posts: 75
    I'm Paul.

    Default

    Thank you guys.
    Just needed that moral support beforehand!

    lf l need spacers, l shall go to Radlett!

+ Reply to Thread



 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •