Originally Posted by
walpurgis
Not everybody will know what this is, so a proper description may assist potential buyers.
True, I do doubt very much though that anyone will want to spend £800 on anything if they dont know what it is, I think potential buyers will know what this is but heres a description.
Gungnir Multibit Digital to Analogue Convertor. (DAC)
D/A Conversion IC: Analog Devices AD5781BRUZ x 4 (2 per channel, hardware balanced configuration)
Digital Filter: proprietary Schiit bitperfect closed-form digital filter implemented on Analog Devices SHARC DSP processor
Analog Stages: Fully discrete JFET buffers for balanced output and discrete JFET summing stages for single-ended output, direct coupled throughout
Frequency Response, Analog Stage: 20Hz-20Khz, +/-0.1dB, 1Hz-200KHz, -1dB
Maximum Output: 4.0V RMS (balanced), 2.0V RMS (single-ended)
THD: Less than 0.005%, 20Hz-20KHz, at full output
IMD: <0.004%, CCIR
SNR: > 115dB, referenced to 2V RMS
All Gungnirs
Inputs: Coaxial RCA SPDIF, BNC SPDIF, Optical SPDIF, USB
Input Capability: up to 24/192 for all inputs
Input Receiver, SPDIF: AKM 4113
Input Receiver, USB: C-Media CM6631A
Output: One pair XLR balanced and two pairs RCA single-ended
Output Impedance: 75 ohms
Clock Management: Bitperfect clock management at all native sample rates via Adapticlock analysis and VCXO/VCO regeneration, plus asynchronous USB Gen 2 module
Power supply: two transformers (one for digital supplies, one for analog supplies) with 8 stages of regulation, including separate local supplies for critical digital and analog sections.
Upgradability: Separate, modular USB Input Card and DAC/Analog Cards are snap-in replaceable.
Power Consumption: 20W
Size: 16 x 8.75” x 2.25”
Weight: 11 lbs
Modified SB Receiver, SB Touch, GustardX16 DAC, Mitchell Alecto Mk2 Upgraded, DCB1 hot rod with BTFSystems LDR and input board, Club27 Kurt Mk2 with crossover upgrade and Laquor pack, Tannoy XT6F, IPL S2TLK CD3, Pioneer PL550 (thanks Andrew) Various TDA1541 CDP's, too much shit I dont use to list.