+ Reply to Thread
Page 3 of 7 FirstFirst 12345 ... LastLast
Results 21 to 30 of 66

Thread: Shure M55EM with Jico SAS stylus

  1. #21
    Join Date: Mar 2014

    Location: KY - Scotland

    Posts: 5,465
    I'm Mike.

    Default

    Can't find a spec sheet for it anywhere online, but reading about it I suspect it's Low Compliance due to the Boron cantilever.

    As for arm matching I haven't a clue.

    There are a few threads about this cart and stylus in here of which this is one of them..

    https://r.tapatalk.com/shareLink?url...7&share_type=t

    Don't know if that helps.

  2. #22
    Join Date: Mar 2014

    Location: KY - Scotland

    Posts: 5,465
    I'm Mike.

    Default

    Over here

  3. #23
    Join Date: Jan 2009

    Location: Essex

    Posts: 31,853
    I'm openingabottleofwine.

    Default

    According to vinylengine, the (dynamic) compliance of the Shure M55E is 25 x 10-6 cm/dyne. It doesn't neccessarily follow though that the Jico SAS replacement stylus assembly will have the same compliance.

    https://www.vinylengine.com/cartridg...s=&prlo=&prhi=
    Barry

  4. #24
    Join Date: Mar 2014

    Location: KY - Scotland

    Posts: 5,465
    I'm Mike.

    Default

    Still for sale for some reason?

    Close offers accepted

  5. #25
    Join Date: Mar 2014

    Location: KY - Scotland

    Posts: 5,465
    I'm Mike.

    Default

    Anyone ?

  6. #26
    Join Date: Mar 2014

    Location: KY - Scotland

    Posts: 5,465
    I'm Mike.

    Default

    Bored yet? I am

  7. #27
    Join Date: Mar 2014

    Location: KY - Scotland

    Posts: 5,465
    I'm Mike.

    Default


  8. #28
    Join Date: Mar 2014

    Location: KY - Scotland

    Posts: 5,465
    I'm Mike.

    Default

    This is still here, any offers before I forget about it?

  9. #29
    Join Date: Mar 2014

    Location: KY - Scotland

    Posts: 5,465
    I'm Mike.

    Default

    Still on sale

  10. #30
    Join Date: Mar 2014

    Location: KY - Scotland

    Posts: 5,465
    I'm Mike.

    Default

    PM that I received yesterday replied to

+ Reply to Thread
Page 3 of 7 FirstFirst 12345 ... LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •