Hi Andy
Watch you dont put too much heat in to the copper track on the board you can damage that too...
Steve..
Turntable; Rega p8
Cartridge; Alpheta mc
Phono Stage; Rega Aria, Bigbottle 3 mm/mc
Amplifier; Rega Elicit
Speakers; Rega Rx3
Yep will do have ordered a case from Aliexpress in the meantime Black Alu
Hi Andy
Aluminium is best suited for what your doing.
Aliexpress were pretty quick at delivering my cases.
Hope it's the same for you.
Steve...
Turntable; Rega p8
Cartridge; Alpheta mc
Phono Stage; Rega Aria, Bigbottle 3 mm/mc
Amplifier; Rega Elicit
Speakers; Rega Rx3
ok component removed and swapped, thanks for all the advice Just waiting for the case from china and wire switch from Taiwan before more bodgery
Sent from my SM-G950F using Tapatalk
At the cutting edge of Numptyness!
thanks feeling smug/relieved !
Sent from my SM-G950F using Tapatalk
At the cutting edge of Numptyness!
Hi Andy
I see you have fitted 1.8 ohm 2% resistors in the vital spot.
Should give you around 750 Ma.
Board looks good mate.
If your gonna have an led on your power switch you'll need to remove the single led and use that to power the front case light.
Steve...
Turntable; Rega p8
Cartridge; Alpheta mc
Phono Stage; Rega Aria, Bigbottle 3 mm/mc
Amplifier; Rega Elicit
Speakers; Rega Rx3
Location: Newcastle-upon-Tyne
Posts: 76
I'm Keith.
Just about finished my project with the addition of some 2mm aluminium angle under the Fets and across the 4 rectifier. Bought some 30mmx30mmx12mm heat sinks that are self adhesive and stuck to the aluminium angle. Fets and rectifiers are hot still but no problem pressing fingers onto them hard and leaving them there. Might get a couple more and stick them to the other side of the vertical ones on the rectifiers just to make sure.
I have 1.2R resistors and get about 852mA output from one side and 882mA from the other. Is it worth the effort to match them?
KR
Keith.
Sent from my SM-G935F using Tapatalk
Garrard 401, Groovemaster 2, Arche headshell, Miyajima Shilabe, Paradise Phono amp,
Aqua La Voce dac
Salas DCB1
Najda active crossover and DSP.
Crown XLi 1500 x 2 bridged, Neurochrome Mod 86 monos, Guy Sergeant Hiraga Le Monstre,
DIY open baffle with 18" Fane Colossus XB, Beyma 12p80ND and Beyma TPL150H with BK XLS 400 sub.