Cable and attenuater arrived at last, time for some more dumb ass questions before getting the soldering iron out
Sent from my SM-G950F using Tapatalk
Cable and attenuater arrived at last, time for some more dumb ass questions before getting the soldering iron out
Sent from my SM-G950F using Tapatalk
At the cutting edge of Numptyness!
Thinking of layouts, the preferred one so far, as per previous builds the alu plate will act as a spacer under the extenders as they are not quir tall enough. I'll cut a couple of pieces off to go under them. Might use a bit for a heat sink on the MURs also if needed.
Sent from my SM-G950F using Tapatalk
At the cutting edge of Numptyness!
Thanks Oliver will do , now measuring holes for the feet. Solid alu with sorbothane pad and o ring .
Sent from my SM-G950F using Tapatalk
At the cutting edge of Numptyness!
Location: Newcastle-upon-Tyne
Posts: 76
I'm Keith.
Would it not be better to have the attenuator and the selector swapped over? Selector next to the inputs and volume next to the outputs?
Sent from my SM-G935F using Tapatalk
Garrard 401, Groovemaster 2, Arche headshell, Miyajima Shilabe, Paradise Phono amp,
Aqua La Voce dac
Salas DCB1
Najda active crossover and DSP.
Crown XLi 1500 x 2 bridged, Neurochrome Mod 86 monos, Guy Sergeant Hiraga Le Monstre,
DIY open baffle with 18" Fane Colossus XB, Beyma 12p80ND and Beyma TPL150H with BK XLS 400 sub.
Yes ideally but the holes are marked vol and select so id like it to match. Won't matter too much once the lid is on.
Sent from my SM-G950F using Tapatalk
At the cutting edge of Numptyness!
before drilling holes in anything decided to take advantage of my new virtual reality software (pencil) to test the placement of components so none obstruct the other. Good job too , some advantages to decorating a bedroom and having left over lining paper !
Sent from my SM-G950F using Tapatalk
At the cutting edge of Numptyness!
Location: Newcastle-upon-Tyne
Posts: 76
I'm Keith.
Garrard 401, Groovemaster 2, Arche headshell, Miyajima Shilabe, Paradise Phono amp,
Aqua La Voce dac
Salas DCB1
Najda active crossover and DSP.
Crown XLi 1500 x 2 bridged, Neurochrome Mod 86 monos, Guy Sergeant Hiraga Le Monstre,
DIY open baffle with 18" Fane Colossus XB, Beyma 12p80ND and Beyma TPL150H with BK XLS 400 sub.
Location: Newcastle-upon-Tyne
Posts: 76
I'm Keith.
What is the hook up wire btw?
Sent from my SM-G935F using Tapatalk
Garrard 401, Groovemaster 2, Arche headshell, Miyajima Shilabe, Paradise Phono amp,
Aqua La Voce dac
Salas DCB1
Najda active crossover and DSP.
Crown XLi 1500 x 2 bridged, Neurochrome Mod 86 monos, Guy Sergeant Hiraga Le Monstre,
DIY open baffle with 18" Fane Colossus XB, Beyma 12p80ND and Beyma TPL150H with BK XLS 400 sub.
The 6 P's
Proper planning prevents piss poor performance
Good job.