In place , just need to run in some more.
Sent from my SM-G950F using Tapatalk
In place , just need to run in some more.
Sent from my SM-G950F using Tapatalk
At the cutting edge of Numptyness!
Yeah maybe , they came with the case but it would be easy to change. Or get some blingy electro blue ones off the bay. lol
Sent from my SM-G950F using Tapatalk
At the cutting edge of Numptyness!
Hi Andy
Nice badge
Turntable; Rega p8
Cartridge; Alpheta mc
Phono Stage; Rega Aria, Bigbottle 3 mm/mc
Amplifier; Rega Elicit
Speakers; Rega Rx3
Location: Newcastle-upon-Tyne
Posts: 76
I'm Keith.
So is one large heatsink shared across all 4 of the rectifiers not a good idea? I was sure that someone said earlier that they could be mounted off board on the floor of the case and connected to the board with wire like some have done with the Fets in order to get some heat sinking?
Sent from my SM-G935F using Tapatalk
Garrard 401, Groovemaster 2, Arche headshell, Miyajima Shilabe, Paradise Phono amp,
Aqua La Voce dac
Salas DCB1
Najda active crossover and DSP.
Crown XLi 1500 x 2 bridged, Neurochrome Mod 86 monos, Guy Sergeant Hiraga Le Monstre,
DIY open baffle with 18" Fane Colossus XB, Beyma 12p80ND and Beyma TPL150H with BK XLS 400 sub.
The Fets need to be insulated from the case as they have a metal back to dissipate the heat.
If the rectifiers used have a metal tab then they also need to be insulated. There are rectifiers which are fully plastic encapsulated that don't need extra insulation.
Ok So it's sounding rather nice but still a bit of burning in to do . The budget attenuator (£20!) sounds fine but is a bit stiff and "clunky" to use as well as having only 23 steps.
I would like to replace it at some stage with a better quality item that is nicer to use which means either a Khozmo or Acoustic Dimensions item. I think the AD item is more likely to be bought at the moment looking at prices etc.
The AD Attenuators come in 10 or 100k spec, looking on the DIY site they recommend a 20K pot for the board so I'm thinking the 10K is nearest to this. Any potential issues with getting this one?
Thanks Electronumpty
I went with the 100K pot, 10K is too low and into typical SS impedance territory.