Christmas is coming and the DCB1's getting fat......

[smangus]

Hi
When i get some free time from father in law I'll pop over and have a listen.

Very well done, finally up and running.
Will take a little while bedding in but when it does i think you'll love the sound....

Regards Steve...

Cheers Steve

Sure just lmk and we'll sort a time out. Hope things go well for your fil.

Atb Andy

Sent from my SM-G950F using Tapatalk

[smangus]

Thanks Edward

Its had it's frustrations but has been a lot of fun and a good learning experience. Soinds pretty good so far too!

Sent from my SM-G950F using Tapatalk

[JohnJo]

Well done Andy, that's you time served now, you're a full qualified electronumpty

Love the case, hope you enjoy it!

P.S. What current is this running at?

[Mr.Ian]

Testing all seems to work so far!

Thanks to Oliver , Steve and Alan for all the help and encouragement

cheers guys

Sent from my SM-G950F using Tapatalk

Is that the WA19 case in black ?

I am leaning towards this in Gold (QJ-4375)



bit tight on the hight but I think it is doable

[smangus]

Well done Andy, that's you time served now, you're a full qualified electronumpty

Love the case, hope you enjoy it!

P.S. What current is this running at?

cheers should be about 750 ma but i haven't measured it .

Sent from my SM-G950F using Tapatalk

[smangus]

Is that the WA19 case in black ?

I am leaning towards this in Gold (QJ-4375)



bit tight on the hight but I think it is doable

Hi yes it is the wa19 , plenty of hieght in it .

Sent from my SM-G950F using Tapatalk

[Bigman80]

Is it aluminium, more importantly.

[Mr.Ian]

all alluminium with a vented top plate and cheaper than the WA19

But - Downsides
the rear panel nees to be rotated 180 degrees ie mounted upside down to line up the inputs to the selector shaft
the internal height is tight at 65mm (external 75mm)

[Bigman80]

all alluminium with a vented top plate and cheaper than the WA19

But - Downsides
the rear panel nees to be rotated 180 degrees ie mounted upside down to line up the inputs to the selector shaft
the internal height is tight at 65mm (external 75mm)

Looks nice!

Ok, no one sees the back

As long as it fits, it'll be ok. Is it the TX that needs the height?

O

[smangus]

How does it take for a stock spec one to run in? noticing differncs already after 3 hrs.

cheers

Sent from my SM-G950F using Tapatalk