Hi All
I'm in the middle of building my Dcb1turbo, I built my first earlier this year and had it finished by Alan ( Firebottle )
It turned out to be a very good preamp indeed, I then sold this project to Macca on this forum only because Id like to push my next
build and make a few changes, these will be listed along with pictures as i progress with the build.
The Kit used
Bare DCB1 turbo board by Salas rev 3.3 imported from America.
1 X Build kit to start the project
Elma 2 pole 6 way selector switch
Khozmo 50k series attenuator
Audio Note Tantalum resistors
Nichicon caps and Dale 1% resistors throughout the build
Khozmo Attenuator
[IMG][/IMG]
The Kit
The Hypnotize turbo board
[IMG][/IMG]
Board Partially stuffed
[IMG][/IMG]
Almost complete. Im still unsure if I will run this board at 600Ma or 1.2A so have left the 2x47ohm resistors un -fitted
along with the Fets. At 600Ma the Aluminium base will be the heatsink but at over an amp will need some serious cooling.
[IMG][/IMG]
Notice the 8 resistors around the relay, they have now been changed to Audio Note Tantalum.
[IMG][/IMG]
Will update the post as i progress with the build.
The Aluminium Case arrives tomorrow along with some huge heatsinks
then i can start putting my preamp together.
Hi Oliver
Feel free to add to the post as I know your building a DCB! too.
Arriving today Full Aluminium Case
[IMG][/IMG]
[IMG][/IMG]
Steve