Managed to dig a spanner out that was the right size.
Only thing left to do is connect the Traffo and run a ground wire to the inputs and outputs.
Then its on to getting it running at 1.2A.
Managed to dig a spanner out that was the right size.
Only thing left to do is connect the Traffo and run a ground wire to the inputs and outputs.
Then its on to getting it running at 1.2A.
I ordered one of these Toroidy things at the weekend £50 all in is pretty good i reckon. There are cheaper out there though.
Mine was a lot cheaper and not noisy, absolutely silent
Nothing wrong with a cheaper transformer
S.
Turntable; Rega p8
Cartridge; Alpheta mc
Phono Stage; Rega Aria, Bigbottle 3 mm/mc
Amplifier; Rega Elicit
Speakers; Rega Rx3
Mine cost £33 and I'm chuffed that it's silent.
It could have been a duffer but i guess i was lucky
If however i had seen the toroidy before i bought thats what I'd have ordered .
Turntable; Rega p8
Cartridge; Alpheta mc
Phono Stage; Rega Aria, Bigbottle 3 mm/mc
Amplifier; Rega Elicit
Speakers; Rega Rx3
Location: Newcastle-upon-Tyne
Posts: 76
I'm Keith.
Where did you get yours Steve? Will it need heat sinks to run at 1.2A? Was just going to run at 600ish but if it can go to 1.2 with the fets bolted to the case floor I might go that far.
Having said that, I have rearranged internally and so need a new front panel as the holes for the knobs are in the wrong place. That means I will have a piece of 400x90x10 aluminium that can be adapted. Bolt the fets to that and bolt that to the floor of the case....Hmmm....
Garrard 401, Groovemaster 2, Arche headshell, Miyajima Shilabe, Paradise Phono amp,
Aqua La Voce dac
Salas DCB1
Najda active crossover and DSP.
Crown XLi 1500 x 2 bridged, Neurochrome Mod 86 monos, Guy Sergeant Hiraga Le Monstre,
DIY open baffle with 18" Fane Colossus XB, Beyma 12p80ND and Beyma TPL150H with BK XLS 400 sub.