Originally Posted by
killie99
Thanks for the link. The brass ones? The steel ones look like they need to be used with metal? Do you just drill the appropriate size hole and knock these in with a hammer or do they need glued/bonded?
Drill the appropriate hole first. I would not go straight for the hammer as the T nuts have a habit of pulling themselves off centre. First pull them into place using a bolt and washer from the other side, then when it becomes difficult to pull them any more you can use the hammer. Good luck.
Source
SW1X Universal Music Server UMS I Signature with Power Supply Unit PSU I Signature
SW1X USB II
SW1X DAC III Special
Audiolab 6000 CDT transport
Amps
Pre amps -- Hi fi Collective twin mono ladder stepped attenuator, with Charcroft Z-foil and silver wired. And First Watt B1 active no gain buffer.
Power amps -- Welborne 45 SET monoblocks 1.8W / Decware Taboo 6W / Elekit 300B TU-8600SVK plus further improved components 9W / ICE Power 1000W
Speakers
Highly modified Endorphin P17 open baffle speakers containing both vintage and modern alnico drivers and paper cones. All silver wired - 8" Cube Audio FC8 full range drivers and vintage 15" Altec VOTT 416 bass drivers. All sat on Townsend Audio Podium seismic isolation platforms.
BK Electronics XLS400FF Sub.
Cabling
Silver mains cables, interconnects and speaker cables by SW1X
Headphones
HRT HeadStreamer and SennHeiser HD650 headphones