Is there a DIY speaker grill cloth (black) that truly has no effect on the sound. If so, where do I buy it?
Is there a DIY speaker grill cloth (black) that truly has no effect on the sound. If so, where do I buy it?
Source
SW1X Universal Music Server UMS I Signature with Power Supply Unit PSU I Signature
SW1X USB II
SW1X DAC III Special
Audiolab 6000 CDT transport
Amps
Pre amps -- Hi fi Collective twin mono ladder stepped attenuator, with Charcroft Z-foil and silver wired. And First Watt B1 active no gain buffer.
Power amps -- Welborne 45 SET monoblocks 1.8W / Decware Taboo 6W / Elekit 300B TU-8600SVK plus further improved components 9W / ICE Power 1000W
Speakers
Highly modified Endorphin P17 open baffle speakers containing both vintage and modern alnico drivers and paper cones. All silver wired - 8" Cube Audio FC8 full range drivers and vintage 15" Altec VOTT 416 bass drivers. All sat on Townsend Audio Podium seismic isolation platforms.
BK Electronics XLS400FF Sub.
Cabling
Silver mains cables, interconnects and speaker cables by SW1X
Headphones
HRT HeadStreamer and SennHeiser HD650 headphones
Location: Redditch
Posts: 15
I'm Pete.
Have used this in the past. http://www.wilmslow-audio.co.uk/grille-cloth-347-p.asp
Source
SW1X Universal Music Server UMS I Signature with Power Supply Unit PSU I Signature
SW1X USB II
SW1X DAC III Special
Audiolab 6000 CDT transport
Amps
Pre amps -- Hi fi Collective twin mono ladder stepped attenuator, with Charcroft Z-foil and silver wired. And First Watt B1 active no gain buffer.
Power amps -- Welborne 45 SET monoblocks 1.8W / Decware Taboo 6W / Elekit 300B TU-8600SVK plus further improved components 9W / ICE Power 1000W
Speakers
Highly modified Endorphin P17 open baffle speakers containing both vintage and modern alnico drivers and paper cones. All silver wired - 8" Cube Audio FC8 full range drivers and vintage 15" Altec VOTT 416 bass drivers. All sat on Townsend Audio Podium seismic isolation platforms.
BK Electronics XLS400FF Sub.
Cabling
Silver mains cables, interconnects and speaker cables by SW1X
Headphones
HRT HeadStreamer and SennHeiser HD650 headphones
Thread title edited, unless you plan to 'grill' the cloth with some onions?
Marco.
Main System
Turntable: Heavily-modified Technics SL-1210MK5G [Mike New bearing/ETP platter/Paul Hynes SR7 PSU & reg mods]. Funk Firm APM Achromat/Nagaoka GL-601 Crystal Record Weight/Isonoe feet & boots/Ortofon RS-212D/Denon DL-103GL in Denon PCL-300 headshell with Funk Firm Houdini/Kondo SL-115 pure-silver cartridge leads.
Paul Hynes MC head amp/SR5 PSU. Also modded Lentek head amp/Denon AU-310 SUT.
Other Cartridges: Nippon Columbia (NOS 1987) Denon DL-103. USA-made Shure SC35C with NOS stylus. Goldring G820 with NOS stylus. Shure M55E with NOS stylus.
CD Player: Audiocom-modified Sony X-777ES/DAS-R1 DAC.
Tape Deck: Tandberg TCD 310, fully restored and recalibrated as new, by RDE, plus upgraded with heads from the TCD-420a. Also with matching TM4 Norway microphones.
Preamps: Heavily-modified Croft Charisma-X. LDR Stereo Coffee. Power Amps: Tube Distinctions Copper Amp fitted with Tungsol KT-150s. Quad 306.
Cables & Sundries: Mark Grant HDX1 interconnects and digital coaxial cable, plus Mark Grant 6mm UP-LCOFC Van Damme speaker cable. MCRU 'Ultimate' mains leads. Lehmann clone headphone amp with vintage Koss PRO-4AAA headphones.
Tube Distinctions digital noise filter. VPI HW16.5 record cleaning machine.
Speakers: Tannoy 15MGs in Lockwood cabinets with modified crossovers. 1967 Celestion Ditton 15.
Protect your HUMAN RIGHTS and REFUSE ANY *MANDATORY* VACCINE FOR COVID-19!
Also **SAY NO** to unjust 'vaccine passports' or certificates, which are totally incompatible with a FREE society!!!
Source
SW1X Universal Music Server UMS I Signature with Power Supply Unit PSU I Signature
SW1X USB II
SW1X DAC III Special
Audiolab 6000 CDT transport
Amps
Pre amps -- Hi fi Collective twin mono ladder stepped attenuator, with Charcroft Z-foil and silver wired. And First Watt B1 active no gain buffer.
Power amps -- Welborne 45 SET monoblocks 1.8W / Decware Taboo 6W / Elekit 300B TU-8600SVK plus further improved components 9W / ICE Power 1000W
Speakers
Highly modified Endorphin P17 open baffle speakers containing both vintage and modern alnico drivers and paper cones. All silver wired - 8" Cube Audio FC8 full range drivers and vintage 15" Altec VOTT 416 bass drivers. All sat on Townsend Audio Podium seismic isolation platforms.
BK Electronics XLS400FF Sub.
Cabling
Silver mains cables, interconnects and speaker cables by SW1X
Headphones
HRT HeadStreamer and SennHeiser HD650 headphones
There isn't any cloth that is truely transparent and doesn't have any audible effect. Chiffon is probably the least invasive, as is any open-weave lightweight cloth.
Bear in mind however, that some speakers were designed to take the decorative grille material into account. Consequently, you should try to find a replacement that is as close to the original cloth, both in appearance (density of the weave) as well as in weight per unit area.
Barry
Location: Solihull
Posts: 716
I'm Martin.
Hi. I have this grille cloth over my speakers. It is relatively cheap so if it does not work for you then little lost
I find that it sounds OK inplace.....but sounds better without.
When its put back it is not nearly as before.....Go figure!!
Its also useful to keep dust off the drivers and it comes in dark brown
Lumley Heliosphere Audiomods 5
Voyd Valdi AN Arm 1 V2 and Denon MC
Audiomeca Talisman Highly Modded
Audiomeca Kreatura &,SW1X DAC1
Hovland HP200 MC
Hovland Radia
Ming Da 805 monos
Magnum Dynalab Etude, RWA Cassabria + LCD 3
Wilson Benesch Actors
Cables by Cardas, Hovland G3 and Yter
Main System
Turntable: Heavily-modified Technics SL-1210MK5G [Mike New bearing/ETP platter/Paul Hynes SR7 PSU & reg mods]. Funk Firm APM Achromat/Nagaoka GL-601 Crystal Record Weight/Isonoe feet & boots/Ortofon RS-212D/Denon DL-103GL in Denon PCL-300 headshell with Funk Firm Houdini/Kondo SL-115 pure-silver cartridge leads.
Paul Hynes MC head amp/SR5 PSU. Also modded Lentek head amp/Denon AU-310 SUT.
Other Cartridges: Nippon Columbia (NOS 1987) Denon DL-103. USA-made Shure SC35C with NOS stylus. Goldring G820 with NOS stylus. Shure M55E with NOS stylus.
CD Player: Audiocom-modified Sony X-777ES/DAS-R1 DAC.
Tape Deck: Tandberg TCD 310, fully restored and recalibrated as new, by RDE, plus upgraded with heads from the TCD-420a. Also with matching TM4 Norway microphones.
Preamps: Heavily-modified Croft Charisma-X. LDR Stereo Coffee. Power Amps: Tube Distinctions Copper Amp fitted with Tungsol KT-150s. Quad 306.
Cables & Sundries: Mark Grant HDX1 interconnects and digital coaxial cable, plus Mark Grant 6mm UP-LCOFC Van Damme speaker cable. MCRU 'Ultimate' mains leads. Lehmann clone headphone amp with vintage Koss PRO-4AAA headphones.
Tube Distinctions digital noise filter. VPI HW16.5 record cleaning machine.
Speakers: Tannoy 15MGs in Lockwood cabinets with modified crossovers. 1967 Celestion Ditton 15.
Protect your HUMAN RIGHTS and REFUSE ANY *MANDATORY* VACCINE FOR COVID-19!
Also **SAY NO** to unjust 'vaccine passports' or certificates, which are totally incompatible with a FREE society!!!
"lack of passion is fatal"
Vinyl: Thorens TD-124mk2 / SME-312 Aluminium 'special' / SME M2-9R / STEREO: Etsuro Urushi Cobalt / Shure M3D / Ortofon SPU A95 / Cartridge Man Music Master / Shure - SC35C (US) / SAEC C3 MC MONO: Miyajima Zero B 0.7mil mono / Miyajima Premium 1.0 / Amps & SUTs: Radford STA25 mk3 / AD Audio 'Satchmo2' pre & LCR phono / Hashimoto HM-7 SUT / ETR-MONO SUT Digital: Audio Note 4.1 (with DAC5 upgrades) DAC / Roon / Tidal Speakers: Tannoy 12" MGs' in RFC custom 'Rutland' Cabinets with RFC crossovers / Tannoy ST-100 Super Tweeters Cables: LFD Grainless phono / RFC Mercury / Duelund DCA16GA tinned copper / Kimber 12TC / SW1X Audio Design USB-SPdif / Duelund DCA20GA interconnects / SW1X Audio SPDIF Aero 6 / Mains Power Conditioner / Box Furniture rack / Audiodesk Systeme Vinyl Cleaner / a very beautiful & understanding Wife!
Location: Nothamptonshire
Posts: 164
I'm Sharif.
I think it was this company that I used for the Acoustic Speaker Grill Cloth for my JBL L40's
https://www.comtecdirect.co.uk/produ.../PG5658/812824
Sharif.