Thought I would have a go at making a few interconnects , I started with the klotz 5000 and ms audio plugs , and then purchased some neotech nemoi
5220 which has 2 flat solid copper conductors in Teflon and again used ms audio plugs , this cable has replaced some audionote anv solid silver cable
from my audionote dac sig 2.1 and sounds great , the dac already has the solid anv inside , I find the solid silver cable to be precise but hard sounding
and lacking a bit in weight , the neotech cable is more musical and as precise , so I ordered more to go from my tisbury pre amp to my ming da 805 monoblocks , now in this position the klotz 5000 sounds better than the neotech , the klotz 5000 also sounds worse compared to the neotech in the
dac position , basically I'm thinking that there isn't enough copper in the neotech cable for the pre amp to monblock position , so I was going to put
both conductors to the plus and use the shield for the return , I know folks on hear have probably done this so can advise on the outcome , the conductors in the neotech cable are 0.22x1.78 each any advice would be helpful .phil