Originally Posted by
gwernaffield
i have been asked the best way to set the gyro up,, with out any Mods ,you have to follow the Michell instructions,, i am not sure how the Cam effect works on the old style adjuster ,, on the new style the spring base acts like a cam centering the motor pod
and tightening the belt ,, the Michell bounce i think happens when the motor pod is clear of the chassis after getting the platter level ,,with in the spec that Michell has set out in the instructions,,
you will need to do the same with the pylons,, accept there is no lateral movement ,, just vertical,, they still should be the same height ,, if you have installed the 3 pads in the suspension ,,you may have to use the bottom drive groove in the platter to keep the height of the belt in the correct position ,, that is all,, or add a rubber pad to the base of the motor ,,the same as above ,,
in doing the pylons no one has said if the o-rings supplied have been too short ,or too long ,,
keep well
pete