New from RFC comes this specially formulated contact cleaner and lubricant:

A superb specially developed contact cleaning and lube solution, designed to remove oxidation and grease and leave a very thin film of protective oil on contact surfaces, enhancing electrical contact for increased signal integrity and decreased wear at connector joints. By virtue of the Quantum Tunnelling effect, this thin film between mating conductive surfaces has excellent electrical conductivity properties. Two part formula uses a solvent based cleaner and low volatility (it doesn’t readily evaporate) light viscosity synthetic base oil. Only a tiny amount is needed, and one 5ml bottle will easily treat all connectors for an entire system!

Named after the Reference Series of products, this is an excellent cleaner and contact lube for all Interconnect RCA’s and XLR’s and is also suitable for use on mains plugs. Your connectors once treated with this solution will benefit from the following solution characteristics:

De-greases and cleans plated surfaces
Removes oxidation, light tarnishing and dirt
Leaves a protective thin highly conductive layer which increases effective contact area
Improves conductivity
Prevents against future corrosion and tarnishing
Very effective for all plating surfaces including Gold, Silver and Rhodium and Copper plated contacts
Effectively reduces future wear on contact surfaces
Reduces intermittent faults by improving connections
Low evaporative loss
Highly stable synthetic material
For most contacts, all that is needed is a wipe down with a lint free clean cloth, followed by application of Planet Protector using one of the cotton wool buds supplied. Only a very small drop should be used. Once the bud is lightly dampened, the component surface should be wiped vigorously and the opposite end of the bud used to clean any excess off. For heavy tarnishing and oxidation, the use of a light abrasive and a very small drop of the solution is recommended. For treatment of mains plugs and IEC’s please allow sufficient time for evaporation of the cleaning solvent before plugging back into the mains (10 minutes should be sufficient). Do not over apply, and avoid contact with plug housings made from polycarbonate or ABS plastics.

Supplied in a 5ml bottle with a pack of 5 cleaning buds



Price is £11.95 plus P&P for 1x5ml bottle (5 application buds and instructions included).

The best value contact cleaner, lubricant and enhancer on the market, why pay more!!!