Wax finish or ? For birch plywood?

Printable View

21-02-2019, 20:03
philv

Wax finish or ? For birch plywood?

I have a birch plywood turntable plinth.

Looking for a simple way to protect/finish it.

Is beeswax or some over wax suutable?
Apply, buff to a soft sheen?
No dissasenbly of turntable required?

Good or bad idea?

Thanks
21-02-2019, 21:56
philv

Or recommend a good clear lacuer spray?
21-02-2019, 22:06
Firebottle

Use a penetrating wax such as Briwax, very easy to use.
21-02-2019, 22:37
Cycleallday

Try Danish oil - easy to apply and gives a lovely rich sheen while keeping the wood grain visible. Also provides a nice hard protective finish.
21-02-2019, 23:01
walpurgis

Bear in mind that applying a wax or oil based finish may make it difficult to use a lacquer or varnish at a later time should you wish to. And vice versa of course.
22-02-2019, 08:17
YNWaN

Also bear in mind that the chap who actually made the plinth (I believe you bought it from another member of this forum) very likely applied a finish themselves.
22-02-2019, 13:05
Svend N

Quote:

Originally Posted by philv

I have a birch plywood turntable plinth.

Looking for a simple way to protect/finish it.

Is beeswax or some over wax suutable?
Apply, buff to a soft sheen?
No dissasenbly of turntable required?

Good or bad idea?

Thanks

Philip, you might consider a combination wax-oil finish like Osmo Poly-X, which would give you the benefits of both a penetrating oil and a wax finish. I recall it being mentioned in a few threads here, by folks using it for the same application as yours and for speaker cabinets. It is supposed to be great stuff. Made in Germany, quality product by all accounts.
22-02-2019, 13:16
struth

just remember wax isnt a major protector, its more aesthetic. a sealer like polyurethane varnish etc will give better protection . but if its just to get a nice look and you dont mind renewing now and then there are nice waxes out there. it is helpful to know what is already on the wood in question tho as some finishes dont go well over others.
22-02-2019, 13:35
struth

you could spray laquer it, if your prepared to remove the deck first(not difficult) this stuff is good and fairly cheap. warm can in water first and shake well. hang the plinth up and spray in well ventilated dust free garage or shed. you can rub down and give a few coats.

https://www.amazon.co.uk/Simply-SP-0...spray+fast+dry