-
-
A thick headshell spacer in ebony.
I was asked to make a 10mm thick headshell spacer.
Pictured here on my test headshell.
https://uploads.tapatalk-cdn.com/201...1200f8940a.jpg
https://uploads.tapatalk-cdn.com/201...c5a2ca1e1d.jpg
https://uploads.tapatalk-cdn.com/201...d08521d9ae.jpg
Sent from my Pixel XL using Tapatalk
-
Here's a solid ebony armboard for the Technics SL-1210mkII.
This one is to fit an Ortofon TA110 tonearm.
Easy fitting from above using my bespoke fitting kit.
I get quite a few enquiries for fast change boards, so more than one arm can easily be used.
Just three bolts and it's out.
I also do a bolted from underneath fitting.
https://uploads.tapatalk-cdn.com/201...7e7fa48351.jpg
https://uploads.tapatalk-cdn.com/201...12d68e6b7c.jpg
Sent from my Pixel XL using Tapatalk
-
Step Up Transformer sort out project.
These were very nice 1:100 transformers put in a turned barrel style case, all done by someone else..
Problem was the transformers were not shielded. There was an attempt at shielding but the face plate was wooden.
They hummed big time.
I totally encapsulated the transformer assembly in MUmetal. I turned a copper faceplate that I MUmetal lined.
I mounted the transformer sandwich construction to the faceplate using brass threaded spacers. Transposed the phono sockets and wiring.
Then I MUmetal covered the wiring area.
Tested on my system.
No hum :)
https://uploads.tapatalk-cdn.com/201...55b6d3274a.jpg
https://uploads.tapatalk-cdn.com/201...1fb8cfd4ad.jpg
https://uploads.tapatalk-cdn.com/201...2628d5f481.jpg
https://uploads.tapatalk-cdn.com/201...b777d45006.jpg
https://uploads.tapatalk-cdn.com/201...9bbd53b992.jpg
https://uploads.tapatalk-cdn.com/201...fcf8c8d05a.jpg
https://uploads.tapatalk-cdn.com/201...cd99831988.jpg
https://uploads.tapatalk-cdn.com/201...8356e42992.jpg
https://uploads.tapatalk-cdn.com/201...266f2c567c.jpg
https://uploads.tapatalk-cdn.com/201...ef4b8d120b.jpg
Sent from my Pixel XL using Tapatalk
-
-
The pair of Vitavox S2 compression driver to loudspeaker horn fitting rings are now tapped and fitted with Imperial threaded studs, washers and nuts.
All ready to be sent to their new home in Canada.
https://uploads.tapatalk-cdn.com/201...409a8826a7.jpg
https://uploads.tapatalk-cdn.com/201...594ee9829c.jpg
https://uploads.tapatalk-cdn.com/201...ff480e7d3c.jpg
Sent from my Pixel XL using Tapatalk
-
-
I recognise that SUT, it has very fine sounding Slagle transformers, but needed rather careful placement... lovely job
-
-
Man! these armboards :thumbsup: