That's the spirit! make the most of it all while your body's young enough to cope :)
Printable View
Roughing it for a night in the back of a van will be nowt to a Glasto' veteran like Rich!
Look forward to meeting up again ,Rich (and everyone else)
Mick
I'll be there, looking forward to it, i'll bring a few things but probably leave the speakers at home this time, unless folks are desperate to hear them again?
I could bring my Thiel CS2.2, fully upgraded crossovers and internal cabling. Some have heard them already but not in the finished guise with balanced tweeter output.
Will it be at the same venue as last year? The place was just perfect imo, and a great host.
Edit: Ignore my question, I've just seen that it is :doh:
I don't think I'll ever be ready for THAT beer. Nice going down, but I was farting for England that night. I felt sorry for whoever did my room next morning. Still, there's always lager :)
Finally got my Lenco based TT ready for NEBO 12
https://www.jkwynn.co.uk/Lenco/Pics/Lenco_4_09.jpg
Anyone interested in the whole story behind the build, find it here: https://www.jkwynn.co.uk/Lenco/Lenco_Thumbs.html
Looks great Ken. Is that one of Sien's mats?
Hi Ali,
Yes Sien of SPH, used his long bearing as well.
Used PTP6 top plates.
Under the hood:
https://www.jkwynn.co.uk//Lenco/Pics/Lenco_4_01.jpg
I added an extra steady/mounting plate to the bottom of the bearing
https://www.jkwynn.co.uk///Lenco/Pics/Lenco_02K2.jpg
https://www.jkwynn.co.uk///Lenco/Pics/Lenco_02K3.jpg
Did you have any problems setting up a cartridge in your Original 774?
I couldn't use the stock Eff Length of 229mm as the wires exiting the wand were under the clamp and would pinch.
Came up with my own dimensions using the Vinyl Engine alignment program, measures better than the so called Mission dimensions, which calculate pretty poor.
You can see what I did on the arm and my alignment protractor here: https://www.jkwynn.co.uk//774/774_Thumbs.html